i need to know if a 0s 30 vg with roto start will fit. the motor needs spacer on top of the mounts to work right?

I wonder if any one has tryed the kyosho springs in the rear/front off the truggy???

I didnt think the Losi bells would fit on other type clutches? I dodnt really know about werks clutch material, but I run all Losi clutch parts and I have had the build ub you are talking about before. It happens when you have an extream amount of slippage going on. It comes from having too stiff of a spring, too soft of a shoe on high traction tracks or having a little grease get in there and causing it to slip. Its basicly a low grade meltdown of the shoes. Clean it as best you can and it will wear away but you need to keep an eye on your shoes.

You may just need to try it and see. Shim it if you need to.

had the motor in a rc 8 t kit. i just buy it and try;)

can i get a nice motor and box for 350.

yes..p5 nova and ofna box and batteries for that.

thanks is the ofna box hard to set up ?

See post #14331. Ofna Truggy Box.

sorry long day here. on the box the rear mount line up with the a arms

to run a lipo rx pack or mih 5 cell

Are you running High Voltage servos? If yes than run the LiPo's. If no you can still run the LiPos, but you may or may not have problems with your servos. The choice is yours.

I still dont have the cajones to try lipo on my 9100's in my truck. I make it just fine in a 45 minute main with a 1600mah NiCd.

Run a NiCd rx pack. You may need a glitch buster running Savox servos. Just my experiance with them. They are power hungry:lol: ( he's not laughing, he is eating)

NiMh If anything, Not NiCd