It isn't a "must" have. But there are many positives to having the GEN III tray. Longer throttle/brake servo life, larger battery compartment where you can now use the foam underneath helping protect your lipo's, and better weight distribution.;)

Hotrod Track
 

Oh man that will be some fun! At least that will make my crash location close to the driver' stand LOL! Can't wait to check it out! Thanks for the update!

what do i need for to run a lipo rx pack?

got two bags done. time to start bag c

high voltage servos and receiver or use voltage regulator to bring the volt down to 6v. i have been using this for almost 2 years now without a glitch. only that one of the wire came off at the board. a quick solder fix and its good as new.

saw that. do i need a swith with it? or just un plug it.

The only reason you would really need anything special is if your servos are not high voltage and are not rated for 7.4v. Then you will just need a voltage regulator that drops the voltage down to 6v. Losi and others sell them, they are not expensive.

will my radio set up work a dx3 c :p

thank you guys love this car kit

It is a great kit, and your radio will work fine.

time to think lipo rx or 5 cell mih

1700 reedy life pack in the gen 3 tray.

thanks:p

this wont work will it
http://www3.towerhobbies.com/cgi-bin...&I=LXMAH9&P=SM
for that reedy pack
its all i got

What clutch would you buy?
 

Hey guys,

I have both an 8ight and 8ight-T (both v2's) that I want to clean up and get back on track. I sometime back put all my clutches from both those models and others in a box and you guessed it! I have no clue where it is. (it was over a year ago) :cry: So I need some clutches for both. What would you all suggest I buy?

Thanks for the time and support,
Nick