Losi Truggy
#1741
Tech Fanatic
iTrader: (69)
r these any good or am i better off with stock?
http://www.carolinasrc.com/Webstore/...idproduct=4385
http://www.carolinasrc.com/Webstore/...idproduct=4877
http://www.carolinasrc.com/Webstore/...idproduct=4385
http://www.carolinasrc.com/Webstore/...idproduct=4877
#1742
#1744
The front inner hinge pin cover (plastic piece) sometimes breaks, mainly after a massive jump gone wrong or a collision or both....this results in the hinge pin sliding out, but only if the plactic cover breaks away.
The wing mount will get a bit bent if you are prone to crashing.
The rear outer hinge pin will bend if it takes a bit hits on the rear wheels.
And the steering arm will pop off the ball if you haven't already captured them......apart from those minor things there isn't really much to worry about.
Some guys have problems stripping diff cases, but I haven't had that happen.
Have fun man they are a great truck!!
#1745
Tech Master
iTrader: (17)
i did this steel bump stop conversion to my chassis ages ago but i used a button head screw instead.
this is the part i used
http://www.amainhobbies.com/product_...ducts_id/15267
i found it was easier to get them out once they are worn down.
its way to hard getting the counter sunk screw out
this is the part i used
http://www.amainhobbies.com/product_...ducts_id/15267
i found it was easier to get them out once they are worn down.
its way to hard getting the counter sunk screw out
Last edited by TIX; 11-25-2008 at 01:18 AM.
#1747
interesting....but mine looks cleaner.
Last edited by Integra; 11-25-2008 at 07:30 AM.
#1749
Yep in and out...that easy. Just gotta remove the filter first.
#1753
#1754
#1755
Tech Fanatic
iTrader: (1)
Join Date: May 2003
Location: Was in Toledo, OH now Battle Ground, WA
Posts: 833
Trader Rating: 1 (100%+)
Question for everyone using lipo receiver packs. Who's regulator are you using? I tried a Castle Link, but when I use the throttle and steering at the same time, one will die (I'm guessing because of lack of current). I tried moving the output voltage higher, but no help. I'm thinking of getting a losi one, but since the Castle Link is rated at 10A and the Losi is 5A, I'm not sure. So I was wondering if I'll have the same problem with the Losi regulator. I thought for a sec or two I'd run without one, but the servos were WAY too fast.........