R/C Tech Forums - View Profile: Johnieblaze
R/C Tech Forums

Go Back  R/C Tech Forums > Members List
Reload this Page >

Johnieblaze's Profile

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory

Johnieblaze Johnieblaze is offline

Tech Regular

Last Activity: 12-19-2022 09:39 PM

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 12-19-2022 09:39 PM
  • Join Date: 06-01-2009
  • Referrals: 0

Friends

Showing Friends 1 to 2 of 2

Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. Roelof
    05-28-2020 12:13 PM - permalink
    The chuck has 2 flat spots so it normally can be hold with a wrench to tighten the chuck nut. With that you can clamp it in a vice.
    When the chuck nut is screwed on the clamp will go smaller when tighten it.

    In Dutch I made a manual for someone: http://www.euronet.nl/users/tooms/ftp/Pinchen.docx
    Just put the text through a translator.

    The ring I mention in the manual is just an easy help to get the conical adapter from the sleeve.
  2. Roelof
    05-28-2020 12:43 AM - permalink
    Hello John, All is fine except the virus issue made me jobless and with so many people fired to save costs there is not much work to find.
    I use an ER32 chuck with an 20mm clamp insert. I made some adapters to fit 19.5, 18 and 17mm diameter sleeves which have a small (about 2 degrees) taper, The cuts on the chuck nut I have numbered so I have a scale
    And then it is all about a feeling and making small steps.
    Untitled Document
  3. 07-29-2015 02:24 PM - permalink
    Hi you tell on the 7R thread that you put AE RC8B3 center shafts on your MBX7R , rear exactely same lenght ok , and front slightly longer , how much 1/2 mm ?? Did you run with them ?? No problem with the chassis flex ( for the front shaft) ??? Thank you for your answer , if you can show me a pics (us if you want to out it on the thread ) ????
  4. buckwild7132
    10-19-2011 06:33 PM - permalink
    the werks engine ??????? ben trying to contact u call me if u can 217 691 9014
  5. buckwild7132
    10-19-2011 06:32 PM - permalink
    hey do u still got
  6. PinoyCali
    10-04-2011 01:19 PM - permalink
    Payment sent for crankcase thanks
  7. 04-21-2011 09:14 PM - permalink
    Did you see my PM?

Likes Given

0 Likes

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.