Advance R/C Car R10 2015
#977
Tech Adept
iTrader: (2)
Should be the first place to get them.
http://hobby-square.com/avid-rc-arc-...minum-chassis/
http://hobby-square.com/avid-rc-arc-...minum-chassis/
#982
Tech Master
iTrader: (12)
Been running the car a while now and have an issue that I can't seem to figure out. It seems to chew up the inside edge of the tires in about 3 race days. I'm only running 1.5* camber which is less than what I ran on my previous car and tires would last almost a whole season. I remember reading somewhere about if your springs are too hard or too soft it could cause this issue, but can't seem to find that info now. I'm running kit set up except that I have no shims under the rear suspension mounts. Anybody have any suggestion as to what I can do to to slow down the tires wear?
#984
Tech Master
iTrader: (2)
You could try increasing droop by 1mm all round, my arc & vbc did exactly what you have described,I did this on both cars & increased the longevity of the tyres to double what I was getting previously,but didn't loose any corner speed or handling characteristics ( I ran kit droop settings on both cars before the increase ) hope this may help you
#985
What's a good fdr to aim for when running mod? I'm going to run either a 4.0 or 4.5T mod motor and I'm not sure what the fdr should be around?
#989
#990