Hot Bodies Cyclone
#7441
Tech Adept
Originally Posted by protc3
its no longer needed.on the black cyclone the cutout under the front diff was small and your belt would slightly rub the chassis.the newer kits such as the hara,surikarn and worlds kit do not require that.
Cyclone kit at Stormers
#7444
been building my black chassis since yesterday, I manage to use my Tamiya thrust bearings for the diff and steel dogbones. I will try and use the hard arms and suspension stuff from my TA05 and see if it will go well.
#7445
Originally Posted by protc3
your belt will slightly rub the chassis on that kit.all you need to do is bevel the rear edge of the pocket with a small round file.just enough so the belt doesnt rub.the car works awesome
#7447
Check www.cyclonedepot.com. There are several setup sheets on there including a blank one to use for your own setup.
#7448
Tech Adept
Originally Posted by dodgeguy
I got an updated chassis also with my Stormer kit also. No belt rub on mine.
#7451
i ordered my kit today finally but stormer didnt have the front diff in stock, anyone know where else i can get a front diff? id like to get it around the same time i get the kit so i can build it with the car.
#7452
Tech Adept
Originally Posted by joey
i ordered my kit today finally but stormer didnt have the front diff in stock, anyone know where else i can get a front diff? id like to get it around the same time i get the kit so i can build it with the car.
#7453
Tech Champion
iTrader: (208)
Originally Posted by joey
i ordered my kit today finally but stormer didnt have the front diff in stock, anyone know where else i can get a front diff? id like to get it around the same time i get the kit so i can build it with the car.
Tower shows them in stock.
http://www2.towerhobbies.com/cgi-bin...?&I=LXNZG1&P=7
#7454
will this work?Just for back up, just in case of a mishap.
#7455
Wce woes
Hello,
just finish putting together a Moore speed, i have converted to 48P with a 75t spur gear, i have install a brood co27 stock engine, but for some reason the motor hits the alloy mount and so it wont pull back far enought for any pinions to mesh up ??
cant understand what is going on, as the 48 spur gear has the same diameter as the 64p that come with the kit ??
any ideas/ solutions,
I was hoping to race tomorrow night
cheers Kevin
just finish putting together a Moore speed, i have converted to 48P with a 75t spur gear, i have install a brood co27 stock engine, but for some reason the motor hits the alloy mount and so it wont pull back far enought for any pinions to mesh up ??
cant understand what is going on, as the 48 spur gear has the same diameter as the 64p that come with the kit ??
any ideas/ solutions,
I was hoping to race tomorrow night
cheers Kevin