Besercoe

iTrader: (9)

I have received confirmation from jones that he will be an arc driver. With tc not really being his thing. I hope he gives it a good crack.

pcar951

iTrader: (23)

Has anyone tested with the flex motor mount setup? How does it impact handling, corner speed ect.

Jim C.

nikos2002

iTrader: (30)

Cyrul - Spashett --- together again!!! It just goes to show that the ARC folks are moving in the right direction in finding quality folks to give feedback and support

reg

Hi,
Iv just picked up a pre 2013,
Could someone point me in the direction of a setup for low grip carpet using all the std kit stuff please,
Ill be racing at the same venue as Mr Spashett tomorrow so ill get some pointers hopefully

Besercoe

iTrader: (9)

it changes the feel of the car. Gives it more on power steering. Perhaps at the expense of stability.

Besercoe

iTrader: (9)

We dont race on carpet in aus. But I would look at josh cyruls setup from late 2012. I actually tried it outdoors and it was very smooth to drive. It would have used mostly kit parts. Look for the one with the lower shock position inboard

Josh-n-ya

iTrader: (95)

Just saw that shopviper.com now has smaller 64p spur gears in stock. Yay! They seem to work better for some reason. I rebuilt my shocks with associated 30 and with the green springs feel like it should be good. I am still learning even shock oil (cst)! Haha! Where can you find just set ups for ARC? Is there a specific place on ARC facebook page?

nikos2002

iTrader: (30)

On the ARC USA Facebook page look at the pictures - the set ups are in there.

You asked for the parts - we listened. New rear hubs in stock as well!!

DirtyDog3375

iTrader: (37)

Just wondering what the difference is with the new rear hubs (part number 109023) to the 2013 kit ones?

Thanks.

Besercoe

iTrader: (9)

It is the same part, the new part number contains 2 pieces, instead of the original part having one side per unit.

Josh-n-ya

iTrader: (95)

Thanks again! Can you stock Blitz bodys as well!

nikos2002

iTrader: (30)

What an interesting idea...............

johnsen-dk

Hi

Know it'a a setup choice , but if you run split blocks rear , do you run cut inside or cut outside mostly?? . All summer I have run cut outside on asphalt

Thanks in advance

reg

Looking forward to giving mine a run tomorrow,
Which screws do you remove from the top brace to give more flex?
It's the pre 2013 and totally as kit,I just want to see what difference removing them all make on carpet,

pcar951

iTrader: (23)

I think you'll be removing the top deck screws above the layshaft (4). Keep in mind that the layshaft is not fully secured once the screws are removed...But you'll get some more flex. If you're going to run it that way you should have the flex motor mount kit, P/N is R109022.