3 racing new F1
#1967
Tech Apprentice
What shocks are they?
#1969
Tech Adept
but i read the alloy doesnot supposed to fit the exotek chassis? that looks to fit well. what did you have to sand to make fit?
thanks
thanks
#1970
Those are the aluminum front shocks for the rc18. Just used the long fgx damper shaft.
Yeah, it won't fit without sanding. The part in question is the motor mount, the rear post in the exotek kit for the top deck moved forward couple mm. The old mount hole on the 3racing part is not used anymore. Just sand that piece down some and sand down a small alignment peg that is on the underside of the mount. all the holes line up. There is a slight overhang of the mount but so does the servo, so not a big deal.
Yeah, it won't fit without sanding. The part in question is the motor mount, the rear post in the exotek kit for the top deck moved forward couple mm. The old mount hole on the 3racing part is not used anymore. Just sand that piece down some and sand down a small alignment peg that is on the underside of the mount. all the holes line up. There is a slight overhang of the mount but so does the servo, so not a big deal.
#1973
Tech Champion
Well my Exotek FGX chassis and shorty pack are at the post office and should be delivered tomorrow! Now just to order the car...I'm putting together a group order with my local racers so hope to have that ordered by mid week
#1974
#1978
R/C Tech Elite Member
iTrader: (28)
So I ran my fgx for the first time Saturday. Didn't race as we didn't have enough for an f1 class. My car is a bit of a handful. I think the front end is still to stuff after moving to associated 0.018 1/12 front springs. What is everyone else running in the fe?
#1980
R/C Tech Elite Member
iTrader: (28)
my car is doing a violent front end chatter ( sort of like McLaren's from 2011 ) entering the sweeper off power, and in other high speed sections when getting off power. when i press on the front and rear ends -- the front end feels like the over sprung part of the car.
i''ve tried ASC 0.022 and ASC 0.018 springs. i'm running 3 degree metal plate and the front weight. i'm going to try the 1 degree plate --- but didn't feel like removing a million screws at the track as i wasn't racing.
in my rear end i'm running the std shock, 1 hole pistons and losi 70wt. i've tired the hardest and lightest springs -- didn't make that much of a difference. making the springs softer helped -- but not that much.