Tamiya TRF417
#2491
Tech Fanatic
iTrader: (32)
At first, I was loosing the rear end in the long sweeper all week, then the car started to flip in the sweeper as well?? confusing as this indicated lack of traction followed by too much traction??
Played with all the normal suspect items (shocks/sway bards, roll center, etc), but the only thing that seemed to help was putting a new set of tires on (we have to use sweep at our local track)?
The used tires weren't that old....anybody experience this before...oh ya, running 17.5 blinky on indoor carpet.
Appreciate any experience out there...
Played with all the normal suspect items (shocks/sway bards, roll center, etc), but the only thing that seemed to help was putting a new set of tires on (we have to use sweep at our local track)?
The used tires weren't that old....anybody experience this before...oh ya, running 17.5 blinky on indoor carpet.
Appreciate any experience out there...
#2493
Tech Addict
hi guys, just curious, is there a difference in running the 111t vs 113T spur aside from the different FDRs you can get from the two? is there a difference in top speed/acceleration between the two?
or to make it a little bit more distinct, what's the advantage of running a small spur vs a bigger spur (or vice-versa) when running the same FDR?
or to make it a little bit more distinct, what's the advantage of running a small spur vs a bigger spur (or vice-versa) when running the same FDR?
#2494
so isn't it advisable to get the smaller ones because BL motors have a lot torque compared to brushed motors?
#2496
just wanna know. does the 417x lower chassis fit on 417??
#2497
Tech Addict
I use it to fine-tune the way my car drives. If I am at a small track with low speeds, then I will use a larger spur to get the bottom-end power, and at high speed tracks, I will focus on the top speed from a smaller spur.
#2498
so to change the 417 to the X you need the top deck, chassie, shock tower,
motor mount parts and battery holders? did I miss anything?
motor mount parts and battery holders? did I miss anything?
#2500
Tech Regular
#2501
Tech Apprentice
Question for the guys running the 417x. What motor mount configuration is everyone running on the X, 1 piece or 2 piece?? Since the X has alot of flex already in it??
#2503
Tech Regular
#2505
can anyone help suggest a pinion i should run? im using the 113t spur and dont know how much pinion teeth would be best
thanks
thanks