Associated RC12R5
#1697
Tech Fanatic
iTrader: (12)
Does anyone have a good "lipo" set up for the L4? I put the batt on the drivers side and all the electronics on the passenger side w/ 3/4 oz of weight.... It is getting better but still not quite there. Or would you suggest I just get a R5! :P Whats the difference between the 5 and 5.1?
#1698
Just get a 12R5.1. The difference between the 12R5 and 12R5.1 is the rear pod has been redesigned to be lower and for brushless motors.
With the way you have the LIPO positioned in the L4, when bites comes so will the handling issues.
With the way you have the LIPO positioned in the L4, when bites comes so will the handling issues.
#1700
Tech Rookie
What parts do I need to convert my R5 into R5.1?
#1701
#1704
They don't seem to be building up right for you. One thing is to make sure when you thread the shock ends on to make sure it threads on straight. It took a little time for me to get it right the first time. The threads are kinda fine so take your time.
#1706
Tech Fanatic
iTrader: (5)
In the middle of the building the front end after the pod, and It s going together as good as My ol' XRay, but yeh is far as the shock ends, I think when they anodized them, some of the blue must have gotten in the hole where the shock shaft goes, cause it take's a "Schwarzenegger" push, to put them on.
#1707
Does anyone know the new rear pod on the 5.1 is the same as the one on the 10R5. I put 10R5 rear pod on the car last season. Just trying to figure out if i should change it out or not
#1708
The rear pod of the 5.1 is closer to the rear pod of the 10R5 Oval car.
I don't know if it's the full rear pod, but most of it is. The part numbers for the parts you need can be found above or one page back.
I don't know if it's the full rear pod, but most of it is. The part numbers for the parts you need can be found above or one page back.
#1710
Hi Beyondthepack. When I built my 12R5.1 for this season, one of my shock ends had some extra material in the hole and was impossible to install on the shaft. I took a small drill bit the exact size as the shaft and cleaned out the hole. Once you do that, it installs without issue. Good luck!