Toy!

http://www.rctech.net/forum/members/...40134-copy.jpg

Shame the box was crushed a little bit during shipping...

I toss the boxes so good by me. :D Congrats.

You've got nearly a year to get it sorted for the Bendigo Classic next year for the rc-mini.net Re-union Nats...

Victoria Australia?

Yep, that's where Bendigo is!

I stripped out my gear the other day; My pinion was only meshing halfway on the gear.

I had upgraded my M05 to a M05v2 so I a unclear on how many mm distance from the endbell of the motor to the to top of the pinion should be so I get a full mesh of pinion and gear.

I think the instructions say 16mm, but I don't think that is enough.

What are other people doing in this area?

You bought a m05 vii chassis right? You need to download the manual for the mo5 vii and look at the gears. You need a 5X1.6mm shim on one of the gear shafts. Then use the jig to set the pinion on the motor shaft. Same distance as it always been

On hunt for a M05/M05v2/M06 located in Edmonton AB, Canada. Anyone of rollers for sale/trade

:lol:

Not sure if I'll be running it any time soon, I've still got my M03 that I need to master.

You have a PM!

Cheers!

PM replied. Thank you for the quick response

,

Can I tempt you one last time Mr Evans?...
Carbon upper and lower decks, alloy bulkheads, BELT DRIVE!!! And Japan quality..
Tech Racing CF/R awaiting your pleasure

http://i410.photobucket.com/albums/p...psuthcsk4v.jpg

I had them on but took them off. They added to much weight. I'm just as fast with them off.

OMG you're going to give poor Jim a stroke......:D At the very least him flying off into a Monkey rage...