protc3

iTrader: (13)

I usually run the body a slight bit higher on the car to make sure it doesnt touch down when the car rolls.

protc3

iTrader: (13)

Im not sure. I will see what i can find out

protc3

iTrader: (13)

Your stuff shipped today buddy

protc3

iTrader: (13)

Hey bill,

We wont be able to make the state race. We are open on saturdays so it is a very rare occasion that i can make those races. Adrian and I will be testing the 1/10th car at adrenaline this weekend if all goes to plan.

protc3

iTrader: (13)

I want to take the time to say thanks to all of those people who sent me emails about there experiences with there new BMI DB12R. We have had such positive feedback on the performance, fit and finish, and support. It makes me happy to see that there have been so many people who purchased the car be faster with our car over there previous car. People are saying that they bought the car for the look of it and never expected to go faster and be more consistant. I am happy to have all of you as customers and satisfied ones at that. I have done all i can to keep parts in stock and readily available and i will continue to do so. We have built up an extremely large inventory of parts. Now all we need is to have the online store up and running and we will be set. Other than that,everything has gone smoothely and according to plan. Again, Thank you for all of your support and i look forward to a strong racing season. Happy racing

Kail

iTrader: (4)

Jason, have you received my pm and email?

protc3

iTrader: (13)

Hey buddy,

I responded to your email this afternoon. If you didnt receive it i will send it again in the morning.

Kail

iTrader: (4)

It didn't arrive Ok sure resend it to me at [email protected]. Thanks

protc3

iTrader: (13)

sent you a pm

redlion

iTrader: (12)

Thanks.

Wes

CraigX

iTrader: (34)

I used to work at a shop where we used vacuum tables and one day we had a tool get caught in a 1/4" piece of aluminum. It ripped it off the vacuum and spun it around and around until it let go and shot through the side plastic window of a Haas VF-6 and shot across our entire shop, went through the corner of a school type locker and shot up in the air and smashed against a cinder block wall. Landed right next to a couple welders that pretty much sh!t their pants. Lucky for the welders the lockers deflected the plate that would have for sure taken one of them out. Lucky for me I didn't get up from my desk a couple seconds early because I was walking that way when I heard some strange noises and then saw the plate smash against the wall. Pretty crazy night.

protc3

iTrader: (13)

OUCH!! I have had my share of impressive F' ups but i chose not to share. I want to have my surface grinder up and going again real soon because those rings work like nothing else.

protc3

iTrader: (13)

That is some hit. I am thinking about it now. I have a HAAS VF-5 and that is a big machine. Similar to a 6 just a hair less Z travel. That part had to be really hauling AZZ to do that. My god, that is some crazy stuff.

protc3

iTrader: (13)

Hey guys,

The DB12R kits are now in stock. All of the pre orders are filled. We have 1 or 2 orders that need to be shipped but other than that, they are all filled. All of the replacement parts inventory has been filled and everything is available for same day shipping as long as the order is placed before 3:00 PM eastern time. If anyone has any questions, i will be happy to help.

BSchorr

iTrader: (101)

ygpm jason