Ko Racer

Im not dave but yes the flap chassis kit is on the market for sale. and you will have to look in japan or hong kong market to get

itchynads

Thanks KoRacer,

Any idea which stores will be carrying it ?

SpeedTech

iTrader: (5)

redbullfixx,

I guess I can expect a full "book" report from you tomorrow? hehehehe

Steve Wang

RedBullFiXX

iTrader: (34)

Yep. pickup the Extra Grande Latte in the morning
And the spool is still ok after a full day

MikeR

iTrader: (15)

Yesser- I will be there!
Steve- are we setting up a Barracuda only zone in the pits We can pass on track conditions and car set ups much easier if we are within earshot.

Ko Racer

sent you a pm with some info

madjack

iTrader: (28)

Has anyone been using the Yokomo bladder caps on their Alex shocks?

I recently put a set on my car but have some concerns over the increased length of the shock.

(looking for a shorter shaft...since a shorter shock body would be out of the question?)

An experiences would be helpful,

JC

JDM_DOHC_SiR

iTrader: (31)

just make sure that you are getting the FLAP R2 chassis and not the R1 vesion!!!!!!!!! ..Because I know for sure the 100% that the ONE FLAG will not work right!!!!! it will hit the batterys!! because it's not offset like the R2 chassis layout

-Dave

Ko Racer

its the R2 version just like in the photo here.
I will have in hand first of next week so I will find out for sure then .

SpeedTech

iTrader: (5)

madjack,

I got the shock caps on my car before I measured them and they seem to be just fine. I roughly measured it after I install them and the bladder cap assembly is a tad shorter than the plastic cap (but plastic cap also go over the shock bodies a little bit when you put them on) so I suspect the overall length of the shocks with the standard cap and bladder cap is about the same. I'll show you tomorrow at SoCal

Steve Wang

Explorer

Steve,

I e-mailed you twice already but no reply? Guess you're super busy. Anyway, please let us know when will the R2 be available. I'm interested to buy one.

Thanks

Herminator

I'm pretty sure he's expecting the next batch in mid may, along with some more spare parts and hopups, like the Speedway PAL drive system I wanted in blue

Explorer

Thanks! What other hop-ups do you think is needed for the R2? Does it have full ball bearings?

SpeedTech

iTrader: (5)

Explorer,

I'll check again when I get to work, but yes, we are getting the next batch in mid May. Thank you for your interest.

Steve Wang

linger

iTrader: (1)

My Cuda is getting dialed.
It qualified 2nd in expert mod at Speedworld and ended up 3rd overall. Not bad for its first mod race.