Team Losi JRXS Type-R
#9001
Tech Addict
iTrader: (2)
attached is the file again.. I also included my version of the setup sheet
I mark my springs with a silver sharpie. I got mine at home depot. This works much better than adding weight or using the dremel to mark the spring.
I had the same problem and fixed this by grinding a 4-40 nut small enough to slide into the hub. My diff never comes loose after this mod.
I was rebuilding the diff and noticed that no matter how tight I set the diff it still slips. I figured out that the suspect part is the plastic diff drive (LOSA3318). With all that aluminum it still acts like a plactic diff because of that one part. It can't stand up to the clamping force exerted by the screw.
Does anybody know of an aluminum replacement part ?
Thanks.
Does anybody know of an aluminum replacement part ?
Thanks.
#9003
I actually think it was designed this way for Mod drivers. Todd made mention of it that it allows a little slip to save the diffs from frequent rebuilds. So yes, it was made that way on purpose.
#9004
#9005
Tech Master
iTrader: (3)
Join Date: Nov 2001
Location: Land of high taxes and bad football
Posts: 1,807
Trader Rating: 3 (100%+)
#9007
#9008
Tech Champion
iTrader: (73)
I honestly believe that some batches of parts are better than others. I have put a kydex bymper from a phi under a hard parma bumper on my car (a few people at our track now run this), it needs some trimming, but nothing crazy, and 2 holes for the posts. This helps a lot.
#9009
Tech Fanatic
iTrader: (7)
Join Date: Feb 2005
Location: Gatineau, QC, Canada (beside Ottawa)
Posts: 818
Trader Rating: 7 (89%+)
with my xray, I was breaking chub almost everynight. + the xray part are double the price of losi price !!!!!
do you have a good bumper?
#9010
Just checked and my C hubs are EA3.
The only bumper on the car is the Losi foam bumper with the small plastic bumper assembly that holds the body posts.
I am not a beginner, so its not a constant crashfest or anything.
The only bumper on the car is the Losi foam bumper with the small plastic bumper assembly that holds the body posts.
I am not a beginner, so its not a constant crashfest or anything.
#9012
Tech Initiate
anyone know where i can get a conversion kit to turn a jrxs to a type r
#9013
Tech Elite
iTrader: (2)
Join Date: Jan 2008
Location: Colorado, USA, The land of the free and the home of the brave!
Posts: 2,880
Trader Rating: 2 (100%+)
#9014
Tech Rookie
#9015