slakr

iTrader: (36)

Flip the mounts upside down (and then the wing mounts from below).

turtle189mt

I'm in Canada so with shipping and exchange plus duty the kit would cost me well over $500 My LHS gives me a deal on kits.

turtle189mt

Thanks tho slakr

ColourGhost

Piece of 10mm fiber glass separating the two high speed sections on our indoor carpet track. 4 cars 30% wrecked, so now we have cut it in a 45 degree angel so it flies over instead of cutting cars in two. Just teasing the other guys about how they should buy this piece of war machine instead of xray xb4. 2 minutes later BOOOOM , -Nemesis

YoG

iTrader: (1)

Great hobbies free shipping kit in stock located in canada.
I dont think you can find a kit in canada for less than five hundred.
Even PM Hobbycraft Ty Tessman home town hobby shop does not even have the buggy listed as of yet.

robbie_gtc

iTrader: (7)

Got mine for $479 from great hobbies before dollar dumped further.
But as suggested. Order from GH. Free shipping in Canada on orders over $100

turtle189mt

They are posting $509 for one now.

nv529

iTrader: (53)

I lost one of my diff shims does anyone know the size of it?

robbie_gtc

iTrader: (7)

Yes cause the cdn dollar has dropped since the last batch they ordered.

You can pre-order from tower hobbies and it will work out cheaper with their coupons. Most likely they will hage more this week or next. Just dont ship it ups. You will get nailed for duty and taxes.

turtle189mt

Oh I know ups is nuts!!!

Sofa King

iTrader: (2)

The one that sits outside the bearing?... think it is 11x14x.2

RC*PHREAK

iTrader: (146)

First for me yesterday. Blew a shock bladder out. Buggy felt like crap during end of qual. Got it back to pits and there was no oil in one of the rear shocks. Tore it down and the was a large tear in the bladder. I am running the AE caps with no screw in the bleed hole so it's vented. Never had an issue before. For the next qual I cut out the bladder, threw a screw in the vent hole and ran 1 emulsion and 3 vented bladder. LOL.

Slotmachine

iTrader: (4)

My car has been turning in in the middle of the corner very hard, it's not loose at all as a matter of fact it traction rolls when I carry too much speed. I decreased Ackerman and that helped but I lost some steering. We're running slicks at our track. I kinda think it is laying over on the front spring or possibly needing a thicker swaybar.

JoeC

iTrader: (120)

I know that this has been discussed before but for you guys that have upgraded to the RcShox ackerman bar have you seen any difference in the handling of the buggy or did it not make any difference. Thanks.

moch8

If anyone is rebuilding their shocks could you measure the actual length of the shock shafts for the front and rear? I want to see if I can substitute a shock shaft from other manufacturers so I can use the industry standard pistons.

Thanks,
Alex