TLR TEN-SCTE 2.0 Kit Thread
#5671
Upgrades really are not needed,however I did get a king heads duel bearing center diff mounts and the center drive pin holders/rubber boots. also the TLR front top steering plate.
Welcome to the REALLY FAST side of 4x4 SC racing............
Welcome to the REALLY FAST side of 4x4 SC racing............
#5672
#5673
#5674
Though i'd share a pic..
#5676
No sir..you can take a small flat blade screwdriver and work it around the bearing and it will slowly come off..
#5677
#5678
The MIP pucks drive lines are nice but added maintenance. You have to replace the pucks every other session with the car or that's what I have to do at least. The only parts I've had break was a ball cup kept pulling off a turnbuckle and the left rear drive shaft broke.
#5679
Tech Master
iTrader: (21)
Does anyone know what the stock degree of caster is in the front? I was away this weekend and noticed that when I took caster out of my 4wd buggy (kyosho zx5) the car seemed to steer better. I went from 10* to 7& of caster... I was wondering if this concept would work with the SCTE as well. Any help?
#5680
Tech Elite
iTrader: (33)
Does anyone know what the stock degree of caster is in the front? I was away this weekend and noticed that when I took caster out of my 4wd buggy (kyosho zx5) the car seemed to steer better. I went from 10* to 7& of caster... I was wondering if this concept would work with the SCTE as well. Any help?
#5683
Drive shafts
Hey Guys,
I'm going to upgrade my drive shafts and outdrives. Anyone used the new MIP Pucks Drive System? I was also looking at the Tekno RC M6 Driveshaft & Lightened Outdrive Set. What do you guys recommend? Thanks.
I'm going to upgrade my drive shafts and outdrives. Anyone used the new MIP Pucks Drive System? I was also looking at the Tekno RC M6 Driveshaft & Lightened Outdrive Set. What do you guys recommend? Thanks.
#5685
I've been using the puck system for a bit now and love it! It's super smooth. The pucks do wear like anything else being part of the drivetrain but is well worth the performance. I know some that has stated excessive wear to pucks but honestly mine have been in for a awhile however I haven't been running big power like some do.