been a minute since seen any setups posted, so figure ill post where i am at right now with mine.

My local Home Depot laughs at traxxas

I'm guessing no one will like these since they are not packed with AVID hopups or ESC trays etc. I just like to keep it clean.

Looks good to me. I live in so md as I see you do as well. Where do you race?

The Track, Bumps and Jumps, Pit Stop and any of the bigger races anywhere I can get people to go.

I'm sure I have run into you at mimi's. You sbould come to tinas in hughesville. They have a decent 1/10 buggy turn out

Not packed with hop ups?? They dripping in Jconcepts and AE hop ups LOL

Are those stainless or Ti screws?

I just meant AVID:-). Ti.

NICE.......

But your missing one key part from Avid. Dude all that jack in your cars and you run aluminum on aluminum in the shock mounts?? Really??

Pony up the $24 and outfit both cars with the bushing mounts at least. LOL

Very nice, basically what I'm doing with mine. I am sticking with the traditional layout, no esc shelf or extra bling. I like old school and am wary of the latest fads and trends.

Was not a fan. The rear ones (b4) did not have enough of a wrench area which made it hard to remove without scratching them up (I use thread lock). I will not likly have these kits long enough to worry about wearing out shock caps.

I remember you saying that. I use this wrench and it fits even the short rear standoff perfectly with no thread lock needed to keep them good and snug. I use these wrenches for adjusting the camber links on all my metric 1/8th cars

http://www.ebay.com/itm/290935449783

I've been running a B4 of some type for ten years. I've had this B4.2 for about six months and this is what the front arms look like.



Is this a common thing with the new car? Did AE change something?

What are you doing?? I have never seen front arms like that in the 10 years I've ran a version of the B4...

I don't know for sure but I think the new plastic is softer. With that said. I have 5- sets I will make you a goo deal on. PM me if interested. I have a number of new b4 parts for sell.