Yokomo B-MAX2 MR/RS
#2431
Tech Master
iTrader: (11)
Bingo. Didn't get the tires I needed until Friday evening because of flooding here. Got them glued in time for the mains, pulled trigger at the tone and dang near flipped the car. Sooo much traction. Cristian says about 4 packs through the pins will wear some, so it may free up a little by itself, we'll see.
#2432
Have next week a run on Astroturf.
My BMax I have a little pimped with front YZ2, lightwight Motor Plate, Aluminum Top Shaft and Rear Hub from YZ2.
I hope in Stock 13.5 and 17.5 (Carpet) bring me forward these changes.
I love this Buggy
My BMax I have a little pimped with front YZ2, lightwight Motor Plate, Aluminum Top Shaft and Rear Hub from YZ2.
I hope in Stock 13.5 and 17.5 (Carpet) bring me forward these changes.
I love this Buggy
#2433
Tech Rookie
Wanted: Front Steering Hub Carrier
Anybody know where to get part B2-413 (C Blocks) for Bmax2? Amain says its discontinued and unavailable. Can anybody source some? Car is only a year old and I'm going to be pissed if it's shot.
#2434
#2435
Last week I had the race in 13.5 Blinky on Astroturf.
I must say that the Buggy is really good and fast. Only the driver was to nervous
TO many driving mistakes to further land forward. A final missed but 2 wins in B final. Guys tried in stock the 72 Main Gear from Revolution Design and the Lightweight Motor Mount and the Aluminum Top Shaft. I think that pushed the BMax even further forward.
I was excited
I must say that the Buggy is really good and fast. Only the driver was to nervous
TO many driving mistakes to further land forward. A final missed but 2 wins in B final. Guys tried in stock the 72 Main Gear from Revolution Design and the Lightweight Motor Mount and the Aluminum Top Shaft. I think that pushed the BMax even further forward.
I was excited
#2436
Tech Master
iTrader: (11)
Time to be pissed then. I tried eBay, etc. too no luck. There's a link a few pages back to some aftermarket carriers. Not sure if they were available in stock 5 degrees but you could check. Other option is the YZ-2 front conversion. Try For Sale here on other forums. I got lucky and picked up a couple sets that way.
#2438
www.rc-race-and-drift-japan.com They have that part and most others. Don't worry he's real good with shipping cost.
#2439
Is there a 3 gear mid mtr transmission for this car. 4 gear is soo mushy.
#2440
#2441
How do you like the new front? What did it do for you? Anything different between the 2 rear hubs?
#2442
It think the YZ front works great on the Bmax. GIves more steering, just not so agressive as the YZ2.
#2443
Thanks. I have built a custom battery brace cause I didn't like the hinge pin. I guess at some point I just buy the new one. But mine still feels new and I have a lot of parts, so b-max2 on.
#2444
Can you post a picture of the brace? I think that the Bmax2 is a great car and I prefer it above the YZ2. The YZ2 is to agressive for me.
#2445
Tech Elite
iTrader: (54)
http://www.rctech.net/forum/r-c-item...l#post14653007
any of you yok diehards interested ? killer deal my trader rating speaks for itself
any of you yok diehards interested ? killer deal my trader rating speaks for itself