Originally Posted by Outtacontrol58 (Post 11677465)

^^^^ Your guys" support should be the standard. Keep up the great work. Just ordered an eb48 6 hours ago from tower. They say all of theirs are the 2nd run buggies. Can't wait!!

Originally Posted by teknorc (Post 11677410)

ALTERNATIVELY, if you don't want to wait for shims, you can simply grind a tiny bit of material off of the diff pinion so the set screw seats properly (recommended). Basically, increase the size of the flat spot on the gear shaft. This will not hurt anything and if anyone breaks a diff pinion as a result of this mod, email us and we'll get you a new diff pinion gear.

Originally Posted by umpy907 (Post 11675737)

Has anybody got the good word from tower :-)

Originally Posted by steelers82 (Post 11677886)

where is everyone already getting these kits from? I pre ordered from tower and a main in the begining of december, and havnt heard anything,and I went on teknos site and it still says backorder,so they cant be getting them from there right?:cry:

Originally Posted by sramos420 (Post 11677867)

Ha, just seen you recommend**grinding it so i think that's what I'll do. Both pinion shafts??

Originally Posted by justpoet (Post 11677633)

Just to clarify for everybody, from looking at where the spacers were going, if we grind it we should grind the flat spot towards the pinion, not towards the end of the shaft, correct?

Originally Posted by teknorc (Post 11678119)

Correct, thanks for the clarification.

Originally Posted by umpy907 (Post 11678401)

Do you know how many kits got sent to tower? I know there was alot of pre- orders and I got my pre-order In a little late so I was trying to figure out if I will get mine on the first shipment :-)

Originally Posted by teknorc (Post 11678415)

We don't really give out that information, but we supplied about half of the pre-orders with the first shipment. So it's hard to say. The next shipment is being packaged now so it won't be too long if you aren't on the initial shipment list.