|
Originally Posted by Cain
(Post 11015526)
what made you use the 8mm mod? Correct me if I am wrong but my understanding is people are using this for traction rolling in high bite conditions.
Speaking of which, at what point (ie- the number of shims under the inner ballstud) do you take off the 8mm riser on the rear hub carrier? |
I run on wet soft clay. And traction can very from corner to corner. I never traction rolled with the mod, but in all honestly, the corners I did roll in, I should have probably slowed down more before the corner. So I took it off.
|
wow with this all being said.. i am going to try them without... too much info all at once!!! i am so confused now :lol: :confused: just got back from ae too.. got some new shims and a new updated top shaft to try with the inner coupler
|
ah, your going to try the pinned top shaft?
|
Originally Posted by Wildcat1971
(Post 11016118)
ah, your going to try the pinned top shaft?
|
The pinned top shaft still slips right. The inside hub is just directly attached to the shaft instead of spinning, correct? The exotek spins on the shaft but locks up the front slipper. The pinned shaft makes it into a b4 style sipper where front and rear slip the same, but the exotek allows the rear to slip and the front to not slip. No?
|
saw the article about AE winning 7 classes at hot rod hobbies shootout. How did it do in the 4wd SCT classes?
|
Originally Posted by Cain
(Post 11016311)
saw the article about AE winning 7 classes at hot rod hobbies shootout. How did it do in the 4wd SCT classes?
|
Originally Posted by Cain
(Post 11016311)
saw the article about AE winning 7 classes at hot rod hobbies shootout. How did it do in the 4wd SCT classes?
|
Originally Posted by fq06
(Post 10999991)
Me too, rx8 and It was useless... couldn't drive 5 seconds without a brown out.
Fine with external bec now, I didn't think I would have to go there with the rx8's 5a bec... but I did. |
must be missing it, was curious on who the drivers were for AE with the SC104x4
|
Originally Posted by Snafujg
(Post 11016428)
Wow. I run a 1258 with an RX8/Novak Ballistic 4.5t, and I never have any brownout issues.
|
Originally Posted by BlueGlowBoy
(Post 11016346)
Looks like Tanner Denney made the A - Main, but didn't podium.
Originally Posted by Cain
(Post 11016429)
must be missing it, was curious on who the drivers were for AE with the SC104x4
Again the SC10 4x4 the red headed step child not really liked at the family reunion but had to be invited because he's family. |
Originally Posted by jamr1130
(Post 11016450)
Denney placed 8th and looked to be the only AE driver in Pro 4 class.
Again the SC10 4x4 the red headed step child not really liked at the family reunion but had to be invited because he's family. Oh well, maybe the next race. |
Originally Posted by Cain
(Post 11016311)
saw the article about AE winning 7 classes at hot rod hobbies shootout. How did it do in the 4wd SCT classes?
|
| All times are GMT -7. It is currently 06:31 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.