OFNA Nexx 10sc Thread
#811
Tech Initiate
That's very good news. And anyone have any recommendations on what fluid to run in the difference? Mainly bashing, slander some track time.
#812
I always ran 3-3-1 in mine but that was with tekin sc4x motor. But if are gonna run that motor I would go with like 5-5-3 or even like 5-7-3. I think it would help get power to ground better with that big motor.
#813
Tech Initiate
Thanks! This is my first build in a LONG time. Now that I work in a hobby shop I feel obligated
#814
Tech Initiate
Horizon was WAY off on the ETA for the Mamba Monster 2. My RX8 with a 2250kv motor should be here tomorrow . Any idea what pinion I should run? I'll be on a 4s battery and am looking for speed and enough torque to bash.
Threads always need more pictures right?
Threads always need more pictures right?
#815
Tech Initiate
This thread is dead, but I'm getting excited
#816
#819
#820
Tech Master
iTrader: (24)
When I had my nexx, I converted a mix of the T-bone and Losi SCTE bumper, it was very very strong.
Pretty much cut the t-bone(Jammin) bumper in half, and added the SCTE clip. Same length as stock. Very stiff, yet flexible. Unbreakable.
Pretty much cut the t-bone(Jammin) bumper in half, and added the SCTE clip. Same length as stock. Very stiff, yet flexible. Unbreakable.
Last edited by Feint Motion; 01-05-2013 at 08:35 AM.
#821
Tech Initiate
For any sort of real bashing I have my T-Maxx. This will mainly see track, road, and some bad dirt jumps. Ok, I guess the last one is bashing.....
#822
Tech Initiate
Anyone know where I can get a shorter sensor wire?
#824
Tech Initiate
Anyone use shims to take some of the slop out of the a-arms? what are you guys using?
#825
I ran my nexx10 with a tenshock 4600 on 4s........umm too fast for its own good.