Hey guys, I went to to my local r/c track and I noticed people had a slightly longer b4.1. I knew they had the +8mm chassis. Do you guys think it is important to have the +8mm chassis? I am running sotck 17.5 buggy. Thanks

I just started running the +8 and run 17.5 Blinky. Have to say it makes a big difference for me. If you run on a bumpy track I find it handles the rough sections better than the stock chassis. I find I can also push it more than I could before. With a longer chassis you may loose a little bit of the turning radius as a shorter chassis will turn tighter, but have not noticed this at all, and we run on a tight 40x60 indoor track. Hope this helps. Oh and I got TQ and took 1st last night, great night out with the new chassis, even ran faster times then Mod.

What seems to be a popular 10.5 to run with a Tekin RS Pro? Its for a mod class 13.5-10.5 mainly on a smaller track. Looked through the last several pages and didn't find much.

What size wheel nut will fit on the hex conversion for front and rear? 8-32 lock nut for front and rear?

Yes. Threads will be the same size front and rear...

Same sized nut that currently secures your rear wheels. The axles only get exchanged in front on the hex conversion.

My guess is that your steering is not really centered. What are the respective lengths of your steering tie rods end to end? If they are not equal, your steering may not be centered.

Just get it. It works better and all newer setups from AE are based on it.....

anytime from now to 1 year

what can i do about traction rolls in a big high speed sweeper, if not flippin it is darn near 3 wheeling

First off I would say Lower your roll center... But whats your set up look like and what kinda track do you run on?

im setup at 24 mm ride front/rear
gold barcodes front and rear( slicks with firm foams)
front 32.5/ orange losi springs
rear 27.5/ white losi springs
middle on front shock tower and outside on the arm
inner on rear tower and inside on the arm
inner ballstud 1mm on front shock tower
inner hole on caster
middle on rear hub and inner 0mm on u brace
i forgot that i lowered my ride height tonight at the track to 23 mm it made a small difference

Argh, trying to search about the hex conversion. What hexes ppl use? Is it AE, JC, Proline or Avid?
Is there a problem with JC hexes, are the screws ok?
And sorry about this question again, but I really tried to find it.
Atleast I didnt want to know the differenses about FT and the Worlds kit ;)

Just buy the AVID hexes, you won't be disappointed! And go ahead and pick up some solid pins from AVID, while you're at it!

What kind of camber are yOu running? Maybe put a 1/4 turn on the turnbuckle towards the negative side.