New Xerun 150a/80a esc-motor combo's
#994
Tech Master
iTrader: (2)
no burnt smell.
i set everything back to default.
still, red light when i turn on, 3 green flashes, no beeps.
still no answer from hobbywing.
i sent an email yesterday to:
[email protected]
[email protected]
and
[email protected]
no answer yet.
i set everything back to default.
still, red light when i turn on, 3 green flashes, no beeps.
still no answer from hobbywing.
i sent an email yesterday to:
[email protected]
[email protected]
and
[email protected]
no answer yet.
#995
Tech Lord
iTrader: (32)
no burnt smell.
i set everything back to default.
still, red light when i turn on, 3 green flashes, no beeps.
still no answer from hobbywing.
i sent an email yesterday to:
[email protected]
[email protected]
and
[email protected]
no answer yet.
i set everything back to default.
still, red light when i turn on, 3 green flashes, no beeps.
still no answer from hobbywing.
i sent an email yesterday to:
[email protected]
[email protected]
and
[email protected]
no answer yet.
#997
Tech Adept
My ESC smells a little bit.....
I lost the radio signal and crashed - the tires were blocked so the esc started to burn, also the motor is not working anymore. I never will drive without failsave again.
I asked Hobbywing about the Overheat-protection: They said, in that case it is not working. Only if the motor or esc temperature gradually increases it will work.
I lost the radio signal and crashed - the tires were blocked so the esc started to burn, also the motor is not working anymore. I never will drive without failsave again.
I asked Hobbywing about the Overheat-protection: They said, in that case it is not working. Only if the motor or esc temperature gradually increases it will work.
#998
Tech Lord
iTrader: (32)
My ESC smells a little bit.....
I lost the radio signal and crashed - the tires were blocked so the esc started to burn, also the motor is not working anymore. I never will drive without failsave again.
I asked Hobbywing about the Overheat-protection: They said, in that case it is not working. Only if the motor or esc temperature gradually increases it will work.
I lost the radio signal and crashed - the tires were blocked so the esc started to burn, also the motor is not working anymore. I never will drive without failsave again.
I asked Hobbywing about the Overheat-protection: They said, in that case it is not working. Only if the motor or esc temperature gradually increases it will work.
#1000
Tech Adept
Aren't these escs supposed to have blocked rotor protection?Ask them.
#1003
http://www.rc-fans88.com/details.asp?prodid=2659
here is your other choice if you want.. i have 2 of the hobbywing 80 amp combo and have not had any problems setting up and running them. the sc8 looks to be a good choice. look on ebay if you have a ebay acc ive seen both combo there to.
here is your other choice if you want.. i have 2 of the hobbywing 80 amp combo and have not had any problems setting up and running them. the sc8 looks to be a good choice. look on ebay if you have a ebay acc ive seen both combo there to.
is that website located in the usa it doesnt say ?
#1004
Tech Addict
Would the 80amp speedo be ok running on 4s in Losi 8e, I will be going for a 2200kv motor and racing outdoors.
Or am i better spending the extra on the 150a version??
Or am i better spending the extra on the 150a version??