I bought, but haven't installed the Jconcepts. The package says it fits both B4.1 and SC10. Hope they fit :)

hmmm Shag my package listed part numbers for b4 t4 and sc10. thats why im asking maybe the shims and spacer parts are different and the axle is the same hope yor right. DAndy jconcepts can you comment?

The axle will work, but they are slightly different. The SC10 axle is slightly longer for more wheel hex support and wheel nut engagement. I actually ran the B4.1 axles on my SC10 for a while because I didn't have any of the SC10 ones...Ha

I haven't ran 1/10th outdoor in a few years. I've recently bought some flip outs and hybrids, is everyone still running open cell foams or has it switch over to CC foam like indoor racing?

It all depends on the surface. If its a really smooth high grip surface then you can use CC inserts. If it kind of bumpy or blown out and dusty you want standard foams.

buy a bunch of new foams and send them to me, I'll break them in for you, thats what friends are for :)

Any word on release fo the b44.2 parts, the Steering parts, and center spur cover, The parts shown in a video a few months back?

I tried Hybrids on that hard packed surface with the fluff on it that I mentioned before and ran 2 1/2 minutes (motor wire came unsoldered... bad mechanic!) and when I was cleaning the tires, they had a good 1 1/2 inch patch of pins just sheered off. These were Greens, first run on them. I ended up just gutting them and taking the foam out and tossing them.

Never had this happen before but I figured I would share in case anyone else had similar results.

Hope so too. Hopefully we'll get this cleared up soon.

+1

I'd like to know too!

Will JConcepts have the new Pressure Points, B44.2 steering rack and other goodies available at Psycho Nitro? :sneaky::sneaky:

Contact us directly and we will get them replaced.

This was just answered 5 post down at 9:16am today :blush:

We will have the Pressure Points available, but the B44.2 parts haven't arrived yet.

Thanks Paul.

I ordered the Ford Raptor SVT SCT-R F-150 (JCI0090) body and on the picture of the example in the packaging it has the fender stickers. I was disappointed when I saw that they were not included. Are they supposed to be included? Do I need to purchase them separately?

Thanks!