JConcepts Thread
#4291
awe bummer was really hoping to get a few
#4296
Tech Elite
iTrader: (22)
What is the intended purpose of the small holes on the inside of the SC Rulux wheels, other than to trap dirt that gets in the wheel inside the tire? Is it possible to change the molds and flash over the smallest holes?
I've been wrapping my wheels in electrical tape to cover the moulded in holes, and venting the tires with a decades old RCPS hole punch.
I've been wrapping my wheels in electrical tape to cover the moulded in holes, and venting the tires with a decades old RCPS hole punch.
#4297
What is the intended purpose of the small holes on the inside of the SC Rulux wheels, other than to trap dirt that gets in the wheel inside the tire? Is it possible to change the molds and flash over the smallest holes?
I've been wrapping my wheels in electrical tape to cover the moulded in holes, and venting the tires with a decades old RCPS hole punch.
I've been wrapping my wheels in electrical tape to cover the moulded in holes, and venting the tires with a decades old RCPS hole punch.
#4298
Will the 12mm Hex adapters work for the new SC10 RS front hubs?
#4299
#4301
#4304
Some racers like to glue the inner side wall to the wheel for added support and the holes allow for this; venting the tires is still needed regardless of the holes. We really haven't seen or heard any concerns regarding the holes until your post. There are no plans to change the mold to cover the holes.
#4305
Tech Regular
Cover holes with vinyl tape vent tire. Problem solved. Lol