Team ORCA USA Discussion Thread
#376
Team EAM
iTrader: (79)
Ive yea to see anyone blow one up. Craig X had a 17.5 at 245 at IIC and it still ran fine but faded at the end of the run for obvious reasons. They are pretty bullet proof thus far.
EA
#377
Tech Master
iTrader: (49)
You can go up to 2mm past the plus sign. Its a pretty significant jump. Ive been 3mm past but have to be careful with gearing at that point. Any further and it will start stuttering.
Ive yea to see anyone blow one up. Craig X had a 17.5 at 245 at IIC and it still ran fine but faded at the end of the run for obvious reasons. They are pretty bullet proof thus far.
EA
Ive yea to see anyone blow one up. Craig X had a 17.5 at 245 at IIC and it still ran fine but faded at the end of the run for obvious reasons. They are pretty bullet proof thus far.
EA
#379
Team EAM
iTrader: (79)
If you bought it from an authorized dealer in the US (They are traceable by serial number on the speedo) It is handled by About RC in Canada. But 4-5 months is not warranty. The warranty is 90 Days on them. I can send you the information if you Email me at TeamEAM @ me.com
#381
what rotor would you reccomend for tc we race on a 60x36 track and i am current geared at a fdr of 3.92 with a non orca motor (the orca is ordered) its coming off at 150-155 with a fan after 6 min run
#382
I'd run a torque rotor, or the largest diameter rotor you can put in the can, if you have that tuning option.
#383
21.5
what is the factory setting on the orca 21.5 for the timing notch? I switched out the sensor board awhile back and forgot to set the timing back to the correct setting.
please and thank you in advance.
please and thank you in advance.
#385
Team EAM
iTrader: (79)
ROAR currently has no one to do speedo testing so the VXX is still not ROAR legal. Until they get someone to do them there is no ETA on when the VXX will be ROAR legal for spec classes.
The VX is legal in all ROAR events for all classes.
EA
#387
Tech Addict
iTrader: (22)
Thanks Eric.
The link that is on the snowbird site for "roar approved motors" doesn't list the TX motors
http://roarracing.com/approvals/brushlessmotors.php
Just signed up on the ROAR forums and now I see it. Thanks again
The link that is on the snowbird site for "roar approved motors" doesn't list the TX motors
http://roarracing.com/approvals/brushlessmotors.php
Just signed up on the ROAR forums and now I see it. Thanks again
#388
Team EAM
iTrader: (79)
Thanks Eric.
The link that is on the snowbird site for "roar approved motors" doesn't list the TX motors
http://roarracing.com/approvals/brushlessmotors.php
Just signed up on the ROAR forums and now I see it. Thanks again
The link that is on the snowbird site for "roar approved motors" doesn't list the TX motors
http://roarracing.com/approvals/brushlessmotors.php
Just signed up on the ROAR forums and now I see it. Thanks again
Thanks
EA
#389
Tech Addict
iTrader: (22)
Anyone have the rotors in stock? Didn't see anything in searching google for the part numbers other than overseas, and didn't see them even listed on any of the sites for the US retailers(About RC lists these as $0.00 dollars so I'm sure thats a mistake)
Looking for -
OTR15MSH (modified rotor)
and
OTR125SN (stock 12.5 rotor)
Looking for -
OTR15MSH (modified rotor)
and
OTR125SN (stock 12.5 rotor)
#390
Gearing help
I just ordered the ORCA TX 17.5T which I will run blinky in my RB6. any suggestions for gearing and timing!
thanks
thanks