protc3

iTrader: (13)

YEAH BABY!!!!!!!!!!!!! GOT MY TICKETS FOR ROY JONES JR. VS. ANTONIO TARVER ON OCTOBER 1ST!!!!!!!!!!!!! WHOOOO HOOOOO!!!!!!!

Racer_Chick

Hey guys,

I just finished building my BMi2 this afternoon before I ran off to work and it looks sweet!! I can't wait to get it on the track tomorrow and see what she can do in 19t. I'll have pics of it tomorrow and the one for the BMI site.

Racer_Chick

OK, here's the new paintjob

johnbull

We found time yesterday to test the new low C of G BMI TC4. Impressive is an understatement. With CS22s that already had 6 runs on them and were therefore pretty lousy, and a checkpoint 7 turn motor that already had 5 runs without a skim and 12 runs on the same set of brushes, the car matched our previous best times.

I had to rethink the steering completely since the first test last week - my post in the previous page refers. I now use mainly Yokomo bits and also have a servo saver in the system. There is still a bit of bumpsteer which I also hope to eliminate, but the cars runs absolutely flat and the tyres wear equally across the tread. Josh says it's alot more precise, responsive and easy to drive.

I hope to get down early next week and have a couple of runs with new tyres and a fresh motor. Should be interesting.

RCknight

iTrader: (5)

do you have any pics of your steering rack? This should be an easy mod, if it works.

SA_Racer

Any Idea when the TC4 Motor mounts will be done?

I need 2 please

johnbull

I'll try and get you some pics.

The steering was the only difficult bit. the rest was a couple of hours work. The whole car looks so low. The cells are about the same height as the top plate.

Tim Stamper

protc3,

Sent ya a PM.

Thanks,

Tim

Indy800

Me too, i need two of those tc4 motor mounts..please...


I was thinking of switching to 48 pitch to try and stop the gear problem what do you think????? If so whats a good size for indoor carpet stock foam?????



AL

TimPotter

iTrader: (15)

TTT

flbugboy

iTrader: (6)

this is to fast of a site to be here on the second page!

protc3

iTrader: (13)

whats going on buddy?how ya been?

lmunno

Here is something I've been working on . . . and working on . . . and working on!!!
Picture is a little fuzzy (protective plastic is still on).

N4S

iTrader: (8)

Speed racer come in !!!!!!! The bridge is out , but ive got good news !!!!!!!

howard hudson

dont talk to me right now Iam racing!!!!!