NEW HOBBYWING STOCK SUPERCHARGED SOFTWARE
No your not adding boost or turbo when set at zero but its a spec rule that the escs leds must blink 2 times a sec which means you need to have the 508 zero timing software to achieve it as the software on the xtreme stock and 2.1v dont have the software feature like the v3 has were you have zero on boost and zero on turbo and the leds blink to indicate zero timing mode.
COBRARACING I take it from your reply that in theory running the 930 firmware with 0 boost and 0 timing it should perform the same as the 508 zero timing except the LED will not flash?
daleburr I take it from your reply that in practice running the 930 with 0 boost and 0 turbo is infact faster than running the 508 zero timing?
This is what I did not want to hear...
As I said I do feel that 930 with 0 boost and 0 turbo is faster but I've never tried them back to back. daleburr confirms that with his dyno test but if the official answer is they should be the same bar the blinking LED then there must be something which means the 508 zero timing is slower than it should be? I was rather hoping to hear that 930 has something like 5 degrees static timing as standard but 508 zero timing does not. Then I could understand the difference and rest easy that my ESC is running as good as it can.
Unless... daleburr have you tested other blinky ESC with your dyno? Would you say it's a deficiency in the 508 no timing or something with the 930 that makes it faster, which is causing this difference?
Thanks for the replies. This is very interesting...
COBRARACING I take it from your reply that in theory running the 930 firmware with 0 boost and 0 timing it should perform the same as the 508 zero timing except the LED will not flash?
daleburr I take it from your reply that in practice running the 930 with 0 boost and 0 turbo is infact faster than running the 508 zero timing?
This is what I did not want to hear...
As I said I do feel that 930 with 0 boost and 0 turbo is faster but I've never tried them back to back. daleburr confirms that with his dyno test but if the official answer is they should be the same bar the blinking LED then there must be something which means the 508 zero timing is slower than it should be? I was rather hoping to hear that 930 has something like 5 degrees static timing as standard but 508 zero timing does not. Then I could understand the difference and rest easy that my ESC is running as good as it can.
Unless... daleburr have you tested other blinky ESC with your dyno? Would you say it's a deficiency in the 508 no timing or something with the 930 that makes it faster, which is causing this difference?
COBRARACING I take it from your reply that in theory running the 930 firmware with 0 boost and 0 timing it should perform the same as the 508 zero timing except the LED will not flash?
daleburr I take it from your reply that in practice running the 930 with 0 boost and 0 turbo is infact faster than running the 508 zero timing?
This is what I did not want to hear...
As I said I do feel that 930 with 0 boost and 0 turbo is faster but I've never tried them back to back. daleburr confirms that with his dyno test but if the official answer is they should be the same bar the blinking LED then there must be something which means the 508 zero timing is slower than it should be? I was rather hoping to hear that 930 has something like 5 degrees static timing as standard but 508 zero timing does not. Then I could understand the difference and rest easy that my ESC is running as good as it can.
Unless... daleburr have you tested other blinky ESC with your dyno? Would you say it's a deficiency in the 508 no timing or something with the 930 that makes it faster, which is causing this difference?
Tech Apprentice
I've tested one other blinky ESC on the dyno, and its performance was very similar to the Hobbywing with 508 firmware, so I think the 508 is doing exactly what we expect. But the 211 firmware that I tested (which should be similar to the 930) is doing something different. I've tested it on two types of dyno (flywheel and slave), and both confirm these results; the 211 with boost/turbo at 0 is still more powerful than the 508.
Tech Apprentice
Xtreme stock
Hi I have the xtreme stock and was wondering were to get a blinks software for my esc
Tech Regular
Hobbywing website.
Tech Elite
iTrader: (102)
Join Date: Dec 2004
Location: Far away from Covid19 but close to 20
Posts: 4,129
Trader Rating: 102 (100%+)
I've tested one other blinky ESC on the dyno, and its performance was very similar to the Hobbywing with 508 firmware, so I think the 508 is doing exactly what we expect. But the 211 firmware that I tested (which should be similar to the 930) is doing something different. I've tested it on two types of dyno (flywheel and slave), and both confirm these results; the 211 with boost/turbo at 0 is still more powerful than the 508.
I am very intetested in seeing the difference .
I was having some issues getting the 211 to ramp up properly, so I had to ramp the throttle up a little slower at the start (as you can see from the slower current build-up), but from 5000RPM upwards its a fair comparison. I need to do a bit more testing on the ramp-up issues, I think it was probably just the voltage cut-off as my flywheel is pretty heavy and draws a big load.
Tech Adept
That's quite a power advantage.
Esc 120 amp 3.0 and 3.1 as well as software 129 have been approved and listed on roars website.
Image attached. The hollow boxes are the 211 firmware, the solid boxes are the 508 firmware. The pink lines are the interesting ones.
I was having some issues getting the 211 to ramp up properly, so I had to ramp the throttle up a little slower at the start (as you can see from the slower current build-up), but from 5000RPM upwards its a fair comparison. I need to do a bit more testing on the ramp-up issues, I think it was probably just the voltage cut-off as my flywheel is pretty heavy and draws a big load.
I was having some issues getting the 211 to ramp up properly, so I had to ramp the throttle up a little slower at the start (as you can see from the slower current build-up), but from 5000RPM upwards its a fair comparison. I need to do a bit more testing on the ramp-up issues, I think it was probably just the voltage cut-off as my flywheel is pretty heavy and draws a big load.
With a slow-ramp up (for both firmwares) the difference is a lot less, although the 211 still looks slightly ahead on power.
Tech Apprentice
Hi. Has anyone tested the custom slope rates on the timing boost and turbo settings?
Tech Regular
iTrader: (37)
Cobraracing, do you know if there is a resolution to the Xerun 150A ESC sensor error?
I've tested two ESCs with 3 different motors and 2 different sensor wires and at about half throttle the red and green lights flash, which I believe means a sensor error. All three motors and sensor wires work fine in sensor mode on a RX8 and MMP.
The motors I've tested are Hobbywing 2000kv, Tekin 1900kv and Tekin 2250kv
Lipo used for testing, 4S 5000mah 40C
I've tested two ESCs with 3 different motors and 2 different sensor wires and at about half throttle the red and green lights flash, which I believe means a sensor error. All three motors and sensor wires work fine in sensor mode on a RX8 and MMP.
The motors I've tested are Hobbywing 2000kv, Tekin 1900kv and Tekin 2250kv
Lipo used for testing, 4S 5000mah 40C