Hot Bodies D413 1/10 4WD Buggy
#8192
#8195
#8196
it is an issue currently for a few reasons. i don't think parts will continue to be on back order too much longer. back in dec i went down to the hobby shop and without hesitation got front shock supports and shock shafts. should be getting better soon.
#8197
Tech Addict
iTrader: (11)
can someone take a picture of there aluminum shock caps installed. I think i know how they are installed but was just making sure i had the plastic bushings in the right spot up against the shock cap and the nut hold them against it. aswell as the placement of the washer. just wanted to make sure i install it right being no manual. thanks
#8198
Tech Addict
iTrader: (1)
can someone take a picture of there aluminum shock caps installed. I think i know how they are installed but was just making sure i had the plastic bushings in the right spot up against the shock cap and the nut hold them against it. aswell as the placement of the washer. just wanted to make sure i install it right being no manual. thanks
#8199
Tech Adept
Thanks guys this could be an issue that would have me looking else where, I'll keep my eye on it for a little before I jump the gun because I know there was an issue with the dock workers in California thanks again
#8200
Tech Master
iTrader: (33)
Just installed my aluminum shock caps and don't like the tilt of the shock when everything is tightened down. Seems like the mount needs to be spaced out a couple mm. Rears mount up fine but the fronts don't look right. Are you guys having similar issues?
Last edited by ironzgti35; 03-05-2015 at 06:47 PM.
#8201