Hot Bodies Cyclone
#6767
Originally Posted by Marcos.J
it will help, are you traction rolling on every turn?
In the final (i was in a crappy final so i had chance to test things) someone said to run 0 deg camber and lay the front shocks down (3rd hole in) and then it was doing it only a few times a lap. That was until about 4 mins in and it started doing it every other corner.
#6770
Originally Posted by L.Fairtrace
Do you have shims under your pivot blocks? IF so take them out or put smaller ones in. that will solve the problem.
If so, then i don't have any shims..but someone said to put 1mm shims underneath all round.
Edit - Does it make a difference that i'm running the black version?
#6771
Originally Posted by raving-monkey
Well i was running the setup that Stew posted (with vtec 24r rubbers) on medium-high bite carpet.....and i just couldn't stop rolling.....no matter what i altered i couldn't stop it rolling. I got most of the problem away, it was just when my tyres got fairly warm that it started again.
Now, would roll bars stop this from happening?
Now, would roll bars stop this from happening?
Please follow the setup more precicely and im sure there will be minimal problems, the only time i had issues with the setup feeling like it wanted to lift wheels and traction roll was when 6/4 droop was tested, i reverted back to 5/5.5 and most tested this and found it to their liking also.
Also your addative routine/brand may be an issue in this too, also if your using tyre warmers....
#6772
I should i said stew. I didn't have everything to follow your setup exactly, so i run it closest i could.
I'm running full additive with LRP carpet. I have ordered some more spacers etc so i can use your exact setup. I'm yet to try carters exactly aswell.
Also, your running a mod with locked centre pulley, will this make a big difference from running 19t with a one-way centre pulley?
I'm running full additive with LRP carpet. I have ordered some more spacers etc so i can use your exact setup. I'm yet to try carters exactly aswell.
Also, your running a mod with locked centre pulley, will this make a big difference from running 19t with a one-way centre pulley?
#6773
Tech Adept
Originally Posted by DENNIS STORTI
well i started to build my snowbirds car. Andy Moore worlds edition with some Jet Racing,3 Racing hopups.they are always nice when there new.
Moore WC Edition kit?
#6776
Tech Initiate
Originally Posted by DENNIS STORTI
well i started to build my snowbirds car. Andy Moore worlds edition with some Jet Racing,3 Racing hopups.they are always nice when there new.
#6777
Tech Adept
Originally Posted by racenut123
no, I think they are 3 racing pullies.
#6778
Tech Adept
Originally Posted by DENNIS STORTI
yes the pulleys are 3 racing very nice setup they give 16,17,18 tooth pulleys
#6779
Tech Elite
iTrader: (9)
Originally Posted by dawgmeat
set for rubber carpet.......is it really needed for the front a-arms to be swept at 2.5 degrees, what the differance from 0-3 degrees???????
#6780
Super Moderator
iTrader: (239)
Originally Posted by dawgmeat
U know what I was truley lookin' for some help from the Cyclone family so I can rep' the cyclone at the birds, FUCK ALL YOU GUYS MORE WORRIED WHAT PRETTY PULLEY SOMEONE HAS