Alex Racing Barracuda R2 & R3
#7757
Tech Elite
iTrader: (1)
RC Champ has some for sale... or they did a week ago, i dunno now. They want about 500 US for a web special.
http://www.rc-champ.co.jp/Champ_Inte...ernational.htm
http://www.rc-champ.co.jp/Champ_Inte...ernational.htm
#7759
R/C Tech Elite Member
iTrader: (47)
Originally posted by rc-zombies
"buyers" several have inquired...but not 100% sure if I want to sell yet... the car just outperformes every car I've ever sedan owned. ... HPI pro, Pro2, Pro3, SD, Xray Evo2, TC3 and some...
"buyers" several have inquired...but not 100% sure if I want to sell yet... the car just outperformes every car I've ever sedan owned. ... HPI pro, Pro2, Pro3, SD, Xray Evo2, TC3 and some...
#7761
now i have a red speedo in a red car
the nosram dominator evolution arrived a few days ago...
i am lucky that triox is the distributeur? for nosram products in germany
the nosram dominator evolution arrived a few days ago...
i am lucky that triox is the distributeur? for nosram products in germany
#7762
Originally posted by JohnA
Excel hubs problem
I've been using some Jet alloy knuckles with a metric 3mm thread (same as the Pal/Excel rear hubs) the king pins that are supplied with the front hubs do not have a 3mm thread, and the hole is too small for the standard 'hat' flange pipe fitting. Anyone got any ideas on a king pin that will fit or some other way of installing them??
Excel hubs problem
I've been using some Jet alloy knuckles with a metric 3mm thread (same as the Pal/Excel rear hubs) the king pins that are supplied with the front hubs do not have a 3mm thread, and the hole is too small for the standard 'hat' flange pipe fitting. Anyone got any ideas on a king pin that will fit or some other way of installing them??
#7767
Originally posted by Randman
Can you get a couple pics up, I can't picture what you're describing...
Can you get a couple pics up, I can't picture what you're describing...
#7769
Originally posted by Randman
OK, I see now.. Just get a tap and rethread the knuckles.
OK, I see now.. Just get a tap and rethread the knuckles.
I know It sounds unlikely but I wondered if anyone had any better ideas, maybe getting the hubs drilled to fit the flange pipes is the way to go.
#7770
Tech Champion
iTrader: (9)
Originally posted by Randman
That's cool, if I ever decide to go back with LRP stuff, it'll be a nosram instead... keepin my red alive
That's cool, if I ever decide to go back with LRP stuff, it'll be a nosram instead... keepin my red alive