LCRC Racway - Oakland Mills, PA *NEW TRACK*
#2402
hello..yesterday was our first time on the track..is there anyone that has some advice on setups for the rc8b and rc8t for lost creek track?we seem to be sagging a bit in the rear..just have a standard setup that was used out of box..any help would be greatly appreciated...thanks ralph
Some of the E-buggy guys are changing the rear springs to the AE silver which is a little heavier. On our nitro buggy we never liked that, but we did go to the gold swaybar and run this.
We'll be there by 7:00am on Saturday and will be more than happy to help out any way we can. Cowboy.
#2403
Tech Master
iTrader: (11)
I have an RC8E but most of my set up is based upon the latest nitro setups:
10 hole 1.1 tapered pistons
30 wt AE oil in the front and 27.5 AE oil rear.
Bronze front springs. Silver rear springs.
Silver sway bar up front and gold sway bar in the back.
Ride height 28mm.
I noticed a big improvement after I moved the rear outer hing pins to the upper hole on the rear hub.
I also like having the 3mm longer 'worlds' chasis at LCRC.
10 hole 1.1 tapered pistons
30 wt AE oil in the front and 27.5 AE oil rear.
Bronze front springs. Silver rear springs.
Silver sway bar up front and gold sway bar in the back.
Ride height 28mm.
I noticed a big improvement after I moved the rear outer hing pins to the upper hole on the rear hub.
I also like having the 3mm longer 'worlds' chasis at LCRC.
#2404
Driver's stand ramp is underway! Should be finished up by Friday Morning. All of the post holes are done and the concrete is poured. Lumber will be here tomorrow and the Smith boys are going to teach me how to make saw dust and read a tape measure starting Thursday morning.
See you all this weekend.
Kevin
See you all this weekend.
Kevin
#2405
Tech Initiate
thanks for the help guys..its a great track...
#2406
Tech Champion
iTrader: (14)
Driver's stand ramp is underway! Should be finished up by Friday Morning. All of the post holes are done and the concrete is poured. Lumber will be here tomorrow and the Smith boys are going to teach me how to make saw dust and read a tape measure starting Thursday morning.
See you all this weekend.
Kevin
See you all this weekend.
Kevin
#2409
Tech Apprentice
#2411
#2413
Wish me luck tomorow. Going for my driver's license test. Stay on the sidewalks!!! LOL!