EAMotorsports discussion thread
#7171
Small issue here.
Regular revtech in a tc6.1. I use all 3 motor screws or 2 depending if ill need to change pinions or not.
Got a new kill shot and the motor holes don't line up. It was late when I finished it but I didn't get a chance to flip the front plate, will that cure it?? Either use the two close holes or the two far ones but have to tear the top section to change opinion. What the hell.
Regular revtech fits fine
Regular revtech in a tc6.1. I use all 3 motor screws or 2 depending if ill need to change pinions or not.
Got a new kill shot and the motor holes don't line up. It was late when I finished it but I didn't get a chance to flip the front plate, will that cure it?? Either use the two close holes or the two far ones but have to tear the top section to change opinion. What the hell.
Regular revtech fits fine
#7173
#7177
#7180
Team EAM
iTrader: (79)
IIC
Anyone going to the IIC and needing batteries, motors or speedo's please send me an email. [email protected] I need to insure I get enough to meet the demand that is going on.
Thanks!
EA
Thanks!
EA
#7182
Team EAM
iTrader: (79)
I believe the order left last Monday from the factory but I have not confirmed that or when I should have them here. As soon as I get them in they will go up on the site though. Anyone that wants to preorder one (No payment required) can email me at [email protected] and you'll be the first to be notified when they arrive at my house.
EA
EA
#7185
Any news on the new ORCA motors being approved yet?