EAMotorsports discussion thread
#6706
#6707
Team EAM
iTrader: (79)
Thanks
EA
#6708
Email sent EA. Thanks
#6709
hey folks, haven't been racing in awhile, but ready to get back for carpet action.
whats happened to EA's website??
whats happened to EA's website??
#6710
#6711
Team EAM
iTrader: (79)
D3's are in and ready to go. Website is still screwed so you can email me at [email protected]
Also all motors now come dyno'd at 0 timing and full timing so customers can see exactly what effect timing will have on the performance of the motor to help figure out gearing and speedo settings.
Thanks
EA
Also all motors now come dyno'd at 0 timing and full timing so customers can see exactly what effect timing will have on the performance of the motor to help figure out gearing and speedo settings.
Thanks
EA
#6716
Ea do you have roomy for Birds yet?
#6717
Team EAM
iTrader: (79)
Thanks to all the guys that Supported EAM at the Birds. I think EAM had cars in every single main in On-road and a few in oval. Thanks to the following guys that I helped with motors or speedo setups that ran well and guys that bought motors from me as well.
Mike Dumas
Mike Blackstock
Donnie Lia
Sal Amato
Rodney Barrett
Jason Graham
TJ Moore
Tim Moore
The website is still screwed up so anyone with questions about orders email me at [email protected]
EA
Mike Dumas
Mike Blackstock
Donnie Lia
Sal Amato
Rodney Barrett
Jason Graham
TJ Moore
Tim Moore
The website is still screwed up so anyone with questions about orders email me at [email protected]
EA
#6718
Team EAM
iTrader: (79)
Large order of 17.5's in and shipping. I think I sent everyone an invoice that ordered. If you had something on order and didnt receive an invoice just Email me so I can get your order out asap!
I should have all others (21.5, 13.5 and 10.5's) in late this week or early next.
Thanks
EA
I should have all others (21.5, 13.5 and 10.5's) in late this week or early next.
Thanks
EA
#6719
EA, is it possible to turbodyno a 17.5 with a boost profile ?
If so would you use a torque or amp load and what would you suggest for settings ?
Would you have to change the profile to make it work ?
Thanks.
If so would you use a torque or amp load and what would you suggest for settings ?
Would you have to change the profile to make it work ?
Thanks.
#6720
Team EAM
iTrader: (79)
EA