XRAY T2’009
#2387
it looks like you are running the diff in the high position. just lower it back to kit or did you do this for setup reasons?
#2391
Tech Master
iTrader: (26)
#2392
nevermind
Last edited by porsche928gs; 05-26-2010 at 07:58 PM. Reason: error
#2393
Tech Elite
iTrader: (147)
The first 08's had 38t pulleys (16t layshaft) to get a 2.375 ratio
One of the few problems people experienced was the rear sway bar touched the diff
They brought out a thicker version of the same mount (same time they supplied layshaft mount to lower the spur & 34/20 ratio's so people could get the right gearing)
You must have an early 08...you can either go back to 34t pulleys or try & source some 09 mounts... deal with someone who knows about Xrays (&all their models)
One of the few problems people experienced was the rear sway bar touched the diff
They brought out a thicker version of the same mount (same time they supplied layshaft mount to lower the spur & 34/20 ratio's so people could get the right gearing)
You must have an early 08...you can either go back to 34t pulleys or try & source some 09 mounts... deal with someone who knows about Xrays (&all their models)
#2396
Tech Rookie
I'm running the 38T and 20T pulleys with the 'normal' diff. When you use the normal motor position, you need rear belt 305446 and frontbelt 305432
#2398
biggest spur
whats the biggest spur you can run without modding the chassis?
#2400