Team Durango DEST210R thread
#1096
Tech Regular
iTrader: (7)
Those are Durango springs. Here's the complete chart:
http://www.team-durango.com/blog/201...spring-charts/
What sort of track are you running on? I run on carpet so my shock setups are probably going to be a lot different than those that run on dirt.
http://www.team-durango.com/blog/201...spring-charts/
What sort of track are you running on? I run on carpet so my shock setups are probably going to be a lot different than those that run on dirt.
#1097
Tech Rookie
Online store
Hi! Will you recommend an Asian (HK,Chine,etc.) store that caries TD parts,please!
Thanks!
Thanks!
#1099
I am going to get my Dest back up running again. I am installing a gear diff this time, with a 10.5 motor, and see how that works out. I will be using the plastic diff gears in it(moulded.) We don't have a class for it yet, but that is always subject to change.
#1100
hey guys I just bought my first Durango...looking for a recommendation on a good setup sheet to start with for MM4 on a medium/high bite clay indoor track. Thanks
#1101
Tech Adept
can anyone tell me what the metal part equivalent for the kit RF suspension mounting, specifically #330341-3, the one that gives three degrees toe in and anti squat. My chassis is the old dest210r one. I think pre type B. Anything from Durango, RDR or whatever will be great. Thank you.
#1102
Tech Master
iTrader: (8)
can anyone tell me what the metal part equivalent for the kit RF suspension mounting, specifically #330341-3, the one that gives three degrees toe in and anti squat. My chassis is the old dest210r one. I think pre type B. Anything from Durango, RDR or whatever will be great. Thank you.
http://www.exotekracing.com/dex210-r...ith-shims-lrc/
or
http://www.team-durango.com/part-inf...artNo=TD330565
#1103
Tech Adept
Kremzeek: Thank you!
#1104
Tech Rookie
chassis
Hi there! Does the DESC and DEST has the same chassis?
#1105
Tech Regular
#1106
.
#1108
Tech Rookie
Re: !
Tanks for reply! The reason I'm asking is Phat Bodies chassis hugging overbody for the Durango DESC210.
Do you think it will fit on DEST chassis?
Do you think it will fit on DEST chassis?
#1109
I have built and rebuilt at least four different transmissions both mid and rear mount and have always had a tight spot when spinning the gears by hand. Has anyone had this issue and did you find a solution for it. I looked at all the gears and transmission cases and can't find anything.
Thanks
Thanks
#1110
Tech Rookie
Re: ?
Over tight diff case,perhaps.