Hot Bodies Cyclone
10-10-2007, 05:23 PM
#9811
Shoot, there not sold anywhere really
How abut these?
http://rc-mushroom.com/product_info....ducts_id=12601
How abut these?
http://rc-mushroom.com/product_info....ducts_id=12601
)?
10-10-2007, 05:25 PM
#9812
10-10-2007, 05:30 PM
#9814
You won't see anything on there website as it's pretty crappy; you need to email them or post a question on there thread here: Champ R/C Adviser
10-10-2007, 05:46 PM
#9815
He bought some on ebay, he said there pretty cheap (25 bucks) and he wanted to try them, and if theres issues, then he will stop using them, so we will see, I think they look good anways
One more question, who makes the best ti ball studs? Long and short for the cyclone?
One more question, who makes the best ti ball studs? Long and short for the cyclone?
10-10-2007, 06:17 PM
#9817
alrighty
Thanks
Thanks
10-11-2007, 01:59 AM
#9820
Under the Pro4 parts you will see the genuin pro4 alloy front, rear and c hubs there.
10-11-2007, 06:17 AM
#9821
Tech Regular
Do any aftermarket company make alu 6deg C hub for the cyclone? I only see the 4deg 3deg and 0deg but no 6deg.
10-11-2007, 08:52 AM
#9823
I've had it since the Hara Edition was released..then upgraded with all the new WCE parts. I like keeping my cars looking new. They get cleaned, dusted and lubed after every race.
10-11-2007, 09:01 AM
#9824
I've had the square knuckles...they broke after 1 run. poorly designed..
Square stuff is usually top notch.
Jet is getting better..using better alloy.
3Racing is good too.. good quality and great prices.
I have the Ti ball studs..so far will all the boards that got in my way
haven't broke one yet.
Square stuff is usually top notch.
Jet is getting better..using better alloy.
3Racing is good too.. good quality and great prices.
I have the Ti ball studs..so far will all the boards that got in my way
haven't broke one yet.
10-11-2007, 11:13 AM
#9825
my square aluminum knuckles have been great i have had them for 3 years now first on the pro4 and now on my cyclone. i did have a ball stud break off in one so i had to get it re-machined with a new thread for the king pin and after that i started running the 3racing ti ball studs as well. no breaks. i have never really had any important parts form jet, just looks and they have held up just fine. i do like 3racing they seem to have made more of an effort for improvement after market then the others with true hop ups that change the car rather then just remaking something in aluminum. either way when you go from plastic to aluminum the parts should always be built better unless you just happened to of got a bad apple that made its way down the line.