Team Losi JRXS Type-R
#7381
Tech Regular
#7382
Tech Fanatic
iTrader: (7)
Join Date: Feb 2005
Location: Gatineau, QC, Canada (beside Ottawa)
Posts: 818
Trader Rating: 7 (89%+)
what is the exact dimension of ''C'' (for the wheel bearing)
A= 3/16
B= 3/8
C= ?
thanks
A= 3/16
B= 3/8
C= ?
thanks
Last edited by maximebeauvais; 06-17-2008 at 10:47 AM.
#7383
Tech Regular
iTrader: (8)
Fast Freddy, as you already know, the bearings in the original JRXS one-way are backwards from that of the Type R one-way. As far as removing them to swap sides... I'm not sure that can be done without messing things up. They're pressed in there pretty good. I haven't seen any successful attempts at swapping them. You're better off getting a new one-way.
Now, if you do get them out to swap them, more power to ya.
Now, if you do get them out to swap them, more power to ya.
#7384
#7387
Tech Fanatic
iTrader: (7)
Join Date: Feb 2005
Location: Gatineau, QC, Canada (beside Ottawa)
Posts: 818
Trader Rating: 7 (89%+)
#7389
http://www.precisionracingsystems.com/products/17 silver is in stock.
#7392
Did you try replacing the outdrive that acts as the nut? I have been running the same spool in mine since I have had it and have not had an issue with it loosening up at all.
#7393
Tech Addict
iTrader: (8)
I have stripped out three of four of them, because of having to keep tighting them. Even running a tight diff, they still loosen up. I am gonna order all new parts and start fresh. I just want something solid. I even tried to put a nut in the end of the outdrive, but ther is now way to really tighten it. I am at a loss. Had to leave racin early tonight cause the stupid thing.
RedRocket
#7394
I am changing from the JR-link to standard camber link to get more on power steering. Is there a photo of the standard camber link setup out there somewhere? any tips for ball stud height etc?
#7395
Tech Elite
iTrader: (46)
Get a prs spur adapter and a smaller spur gear.
http://www.precisionracingsystems.com/products/17 silver is in stock.
http://www.precisionracingsystems.com/products/17 silver is in stock.