Andy63

Anyone know what software works best with 17,5 T Speedpassion and HW extreme stock esc? Also anyone know à good setup??

Thanks!

AGNO

SW 930STOCK

FDR 5,5

4 - DDRS 9

9 - 44°

10 - 18/0,1s

12 - 20°

13 - 3000rpm

14 - 0,1s

15 - 250rpm/deg


This is a good start setup for Speedpassion 17.5

banquer

And for modified races?
GM Delta 7.0T, final ratio 8.00.
I'll receive my Xerun 2.1 120A tomorrow and I don't know which software version to install and setups for it.

Cheers!

AGNO

I'm not sure that the Xerun 2.1 support the motor GM Delta, but I could be wrong ...

Andy63

I have ran the same setup and didnt feel good punch. Suggestions what to change? Thanks alot for helping!!

ufoDziner

iTrader: (39)

Would it be better to run the stock or mod version if I'm running a 17.5 on 3s? Thanks.

Monkeys punk

Running a x12. 17.5 so was going to run the v1.63 software but when I try to install it it just tries to update everytime and won't install unless I do the update. Any sugestions guys ?

Team_Krusty

iTrader: (3)

Hi Andy63,

I dont know much about the Speedpassion motor but maybe the FDR is a bit low for that motor. Maybe try a FDR around 5.8 - 5.9

Simon

defcone

iTrader: (15)

SW 930STOCK

FDR 5

4 - DDRS 9

9 - 40°

10 - Fastest/0,1s

12 - 24°

13 - 2000rpm

14 - off

15 - 150rpm/deg


This is a good start setup for Speedpassion 17.5

This is what I've been using with great results.

TryHard

iTrader: (4)

Tom, just load up up 930stock or 119stock.. And then tweak the settings down. That way no need to use a seperate program when switching between stock/mod.

Btw, with a 4.5t I have run this successfully before;

Fdr: 7.8
DDRS: 1
Drag brake: 10%
Initial brake: drag
Boost: 20
Turbo slope: 12
Turbo timing: 10
Boost start: 15k
Turbo delay: 0.1
Boost ACC: 200

For lower rev punch, shorter boost ACC, lower boost start, and more boost in general... The above was for medium traction, high traction I was on boost 28, start 10k, and accl at 100! Super punch!

HiH
Ed

nutz4rcyktw

iTrader: (67)

First weekend of running my ofna 1/8 dirt late model with the Xerun 80 AMP ESC and 2250 motor combo. I have the ESC attached to the mounting plate and it is attached to the flat plate that extends behind the batt mount. Should I do anything to prevent the ESC case from splitting due to the hard knocks it gets in 1/8 racing? I don't know that it will but just wanted to see if anyone had a solution or this issue. Thanks.

smilekt

iTrader: (13)

o.k no problemm .... see you there ..

TryHard

iTrader: (4)

Same for me, I'll be coming to say hello regardless to Michael, Salton and the gang

COBRARACING

Come and hang out with me ED ok salton and michael will be to stressed to hang out with lol.

banquer

Thanks Ed, i'll try it.
Regards.