TLR 22T Thread
#2236
Tech Initiate
I chucked the turnbuckle into a battery drill, and threaded ea. Ballcup on and off by holding it with a pliers. Then added a dab of grease and threaded 1 ballcup on ea. turnbuckle end. Then do the 1 ea ballcup by hand that i had pre threaded.
#2237
#2238
I'm not running an Orion, but the LRP that is in my son's truck has a huge capacitor on it. The wires were long enough to push the cap through the opening in the shock tower, then I drilled a small hole in the webbing on each of the wing/body mounts and I ran a zip tie through to hold teh capacitor. A perfect fit. I can post a pic if you want.
i use lipo in saddle like the Mid motor position and capacitor are under the ESC
#2239
Spare body
Anybody know where i can buy a spare body?
#2241
#2242
If anyone is interested in all my mid motor parts straight from the kit shoot me a pm. I'm never going to go mid motor so I have no need for the body + parts.
#2243
#2245
Did anyone have to do some trimming on the servo link to get full steering throw out of this truck? Even with my endpoints maxed out on my m11x I'm not hitting the end of the servo's (1258) travel or binding anywhere on the arm/ballcup/wherever.
#2247
Steering rack
Does the steering rack and the servo horn touch or get very close on full turn to the left. Noticed it while building, just hoping I did it correctly.
#2248
Tech Initiate
Hey cman26, what are you gearing your 13.5?
#2250
Yes myself and a friend had to cut a little off one of the cups and also we cut down the set screw between the cups. The truck gets full throw now and steers like the buggy. It was maybe 2mm at most.