Team Corally RDX Touring Car
#3977
Tech Elite
iTrader: (13)
Join Date: Sep 2001
Location: Land of the Free, Home of the Brave
Posts: 2,928
Trader Rating: 13 (100%+)
Originally Posted by Turbonium
i use a 2mm ball end driver to reach the inside roll center adjustments... oh yeah, i also swapped the screws for hex heads... much easier to change roll centers that way.
Yeah, that is what I was kind of figuring. Thanks!
#3978
Originally Posted by Turbonium
i use a 2mm ball end driver to reach the inside roll center adjustments... oh yeah, i also swapped the screws for hex heads... much easier to change roll centers that way.
#3980
Tech Elite
iTrader: (6)
Originally Posted by Roger
I did that also. I changed out the torx screws and used a hex flathead for the rollcenter adjustments. It makes everything easier using a 2mm ball end driver when it comes time to raise or lower the roll centers.
#3981
Originally Posted by josh short
i see that this a good carpet car but what about asphalt???
7 out of 10 in Stock at the ROAR Asphalt Nationals.
#3982
Originally Posted by HarshGuy
You're putting Xray parts on your RDX ...NO SOUP FOR U!!
The ONLY xray part I have on my car is XRAY VISION. My RDX is gonna see through everybodies car as if you weren't there. That means passing will be invisble because i'll be passing you so fast, you wont' even see me .
#3983
Tech Champion
iTrader: (32)
Originally Posted by Roger
hahahahaha ( NO SOUP FOR YOU !!!!! ). My kit came with the cheap red handle torx wrench. I already gone through 2 torx screws and the wrench looks like its toast. Im gonna switch all the screws to allens.
The ONLY xray part I have on my car is XRAY VISION. My RDX is gonna see through everybodies car as if you weren't there. That means passing will be invisble because i'll be passing you so fast, you wont' even see me .
The ONLY xray part I have on my car is XRAY VISION. My RDX is gonna see through everybodies car as if you weren't there. That means passing will be invisble because i'll be passing you so fast, you wont' even see me .
#3986
Originally Posted by STLNLST
I hope you can back that up...
#3987
Tech Master
iTrader: (19)
Originally Posted by STLNLST
You make up your mind yet? You should go ahead and get one. I think it will fit your situation best
Originally Posted by STLNLST
.............besides...... the b-main has got to be lonely!!!!
#3988
Originally Posted by Advil
You tell me....the last time I looked you were the only one in it!
#3990
Tech Elite
iTrader: (161)
Originally Posted by Roger
My kit came with the cheap red handle torx wrench. I already gone through 2 torx screws and the wrench looks like its toast.