westerdude42

I would go a 58 tooth spur and 19 tooth pinion to start with. You can always gear up if you need to. You could also try the heat sink with the built in fan.

PIIHB!

iTrader: (14)

Does anybody make an upperdeck for this car to take out some of the flex? I thought i remembered reading it on here but i cant find it....

westerdude42

It's not TCS legal but the Evo III upper deck goes on with some minor modifications. We put one on an R just to check.

adavid

Adam,

I think Tech makes one, but I couldn't find it on-line (Rainbow Ten, Speedtech) the last time I looked, although that was several months ago. I think you should embrace the chassis flex!

Andy

adavid

Here's the link. About half way down on the page.

http://www.tech-racing.co.jp/op_parts_new.htm

Phenochilus

Does anyone know where I can get some aftermarket rubber sealed bearings for the TB-02 ?

Thanks.

RCGaryK

iTrader: (3)

Check out Boca Bearings.

N0Body

Jep,

but you have to remove the sealed gearbox, right?

PIIHB!

iTrader: (14)

i just put my evo3 upperdeck on. u just need to dremel the rear gear cover.

westerdude42

Just wait, it works well on carpet.

PIIHB!

iTrader: (14)

Here's some (bad) pics.

adavid

Adam,

Looks good. I guess you're not embracing the chassis flex then. Are you running tomorrow at the "C"?

Andy

PIIHB!

iTrader: (14)

Yea, I will be there. Hopefully there will be a differance in the handling. I changed my setup a little.

wyd

iTrader: (51)

PIIHB don't forget we are all going to C on June 4th!!!!!! Cans might even have a new car by then.

Phenochilus

Does any one know of any third party manufacturers that make a carbon fiber bottom deck for the tb-02 ?

Thanks.