TLR 22 3.0 Race Kit Thread!
|
|||
#3361
Tech Elite
iTrader: (166)
Id be worried about them twisting. If that makes any sense. Plus titanium might be too light. My laydown is a pig right now (around 1560), but I have the carpet transmission, so I have the aluminum hubs, and HRC pivot. The Dirt case should be here monday, so I can put the molded pieces back on, i'm ideally going for 1525 total weight with the 21 grams I tucked under the case (like we do with my YZ-2). Car as it is right now still pretty much murders stand up cars due to corner speed with a slight compromise in top speed due to weight. It is way more stable though then the YZ-2 is.
#3362
Will the spindles TLR334028 fit the 3.0?
#3364
Tech Initiate
I trim my rims by running them up on a drill and using a craft knife. Gives a nice clean cut.
I've tried alot of different carpet tyres over the last couple years and always end up back with the Schumacher cut stagers up front and original Mini pins on the rear with AKA closed cell inserts. They give close to the best grip but outlast anything comparable by a mile.
Loving the laydown setup and always battling at the front but struggling to get others to switch over to Losi due to the cost currently.
As for the gearbox bind (when using a gear diff) I make a paper gasket just out of regular print paper and it works a charm to create almost zero drag.
I've tried alot of different carpet tyres over the last couple years and always end up back with the Schumacher cut stagers up front and original Mini pins on the rear with AKA closed cell inserts. They give close to the best grip but outlast anything comparable by a mile.
Loving the laydown setup and always battling at the front but struggling to get others to switch over to Losi due to the cost currently.
As for the gearbox bind (when using a gear diff) I make a paper gasket just out of regular print paper and it works a charm to create almost zero drag.
#3365
Tech Adept
iTrader: (7)
Does anyone know what rear spring this is that Dustin is using on this setup?
Thank you for any help
http://site.petitrc.com/setup/losi/s..._MHOR20160527/
Thank you for any help
http://site.petitrc.com/setup/losi/s..._MHOR20160527/
#3367
Does anyone know what rear spring this is that Dustin is using on this setup?
Thank you for any help
http://site.petitrc.com/setup/losi/s..._MHOR20160527/
Thank you for any help
http://site.petitrc.com/setup/losi/s..._MHOR20160527/
#3370
#3371