Hey guys i want to lose the red black and white servo lead and resolder black ones in.I have opened the servo case and the servo wires where they meet the board have dryed glue from a glue gun (i think).
Whats the best way to remove this without damaging the board in the servo.
Cheers

ANYONE????

Not many people actually do that... Most people sharpie the wires. Take your time and looks just as good.

Yeah i know but after a while it rubs of and then looks like crap.

just color the wires with a sharpie and whatever slack is left in the wire put heat shrink on, then when if it starts to rub off you won't have as much to redo. i'm fairly confident in my soldering skillls, but i don't think i'd wanna resolder wires on a servo

Cheers guys i have decided to just colour the wires and do what you said epic.