Losi, so your diff setups are the same as the Losi drivers. Ofna is good but I would rather know exactly what other people are running, because ofna and Losi are a little different wt.

Mostly the same diff setups. Depends on what track. Thanks. I will see what most are using. I been using different brands for awhile now,But never paid attention, If the weights were different Thanks

wrong again....Rear left and front right.

Mugen oil is water eh....

what im saying is that, the mugen diff oil is pretty thin compared to others
i used it before.

and the bottle top is bad.

I just got a set of 12 degree inclined for my truggy . Should i grind them for more turn in or are they fine stock ?? And also should i run the stock 3-3 rear plate, I have the adj ones on it now thanks

The left hand thread screws are only to be used in the Left Rear and Right Front.

i had the 12 degree in the front and took them off because i could not get throw put the stock one back on i`m going to take the 12 degree grind out alittle

Make sure you dont grid them to far!!

Ohhh I see. Hehehe

Some people take longer

Quick question guys. After installing lightweight out-drives and aluminum hubs i noticed that with 129mm of droop the rear dogbone on the radio tray side was very close to failing out of the out-drive at full extension. I ran the truck two laps and the dogbone popped out on both laps, is there a fix or is there something i may have assembled incorrectly?

check your hinge pins.

Any help ???

For? bends..incorrect installation..ect the kit is brand new out of the box i also have the adjustable toe plates.

Anybody here tried rock oil filter oil? How was it? Also whats another brand of air filters to use, I have been using power save, but A main is out.