I know, I had seen it in the past. But I went back 50 pages and couldn't find it again.

This is the latest one I saw

That's just a blank setup sheet. I was looking for the document that had full explanations of all the new features from 422/528.

unable to view/ open the file

works for me in acrobat 9


this all I have from HW that explains the settings, its for 422.

Thanks. That is very close to what I saw before. It will work well enough.

(1) go to http://www.speedpassion.net/us/index.asp, SIGN UP there...once you you have an account, LOG IN

(2) after logged in...on the left side, above the MEMBER INFORMAITON, is called Warranty Registration and RMA submit, click on that one.

(3) Now...click "CLICK HERE" under the Return merchandise authorization(RMA) area....

(4) fill out all the form and submit...

there you go.

Thankyou Howard and Albert for this info.

here you can find the last setup sheet
http://www.rctech.net/forum/7643991-post4841.html



may be is this one the document? It is inside the 528zip folder with the 2 files for the new firmwares

That's it! Thank you.

Speed Passion GT2 RPM LOG Interface

The news from Speed Passion Engineer, that new interface for Speed Passion
GT2 will be released in late september.

Which will record history from esc during run.

Does anyone know if the SpeedPassion 2.1 ProStock requires a booster or receiver battery for 1s LiPo?

The blurb says it's designed for 1/12th scale but it doesn't say if it has a voltage booster for the receiver...

Thanks!

My friend and i both have SP 2.0LPF's i updated both to the latest 528 stock firmware but something strange has happened. In the settings i have sc rpm delay starting at 4000 then 5000 etc he has 3000 then 4500 any ideas?
I've just downloaded the latest software from the SP site released yesterday still the same.

Are you using a single LCD Programmer box for reading the settings on both ESC?

i think you are using differents program cards, one is using the Hobbywing firmware and the other has the Speedpassion update (i'm talking about the LCD firmwares, not esc firmwares).
So the at the same esc setup lvl one is showing a value that is different from the other program card.

Yeah, that was my thinking as well. The LCD boxes are not at the same firmware version level.