shipping to Philly will be no more then $20 a case if you order from EBMods, or Lucky 7 RC. We're happy you decided to get a JS.

I am leaning towards 25% just because some of the other engines that I have. I don't want to have 20% in one, 25% in another and 30% in something else. Will the JS full mod disagree with 25%? 25 is a good middle ground for everything I have. Let me know what you guys think.

The JS comes shimmed for 25% - 30% nitro.

you should let Alan and Mike from Hobby Hut know you want to buy EBMods fuel. They can order it for you too.

had to get a full mod again as it was the last engine available at amain (made a big order to smuggle back home )

will get a race prep next time i will be in the US (June) so I can compare

25% nitro will work out just fine. Due to Danish legislation, 25% is all we're allowed to race here. As mentioned already, the engine is set up to use 25-30% so you don't have to touch anything. The lower nitro content might make it necessary to use a hotter plug (thank you JPalessi).

just wanted to make sure i'm right. tune this engine from the high speed needle first then the bottom, tuning the bottom so the idle stays steady and doesn't drop, while not touching the idle screw right??? what temps should i be looking for?

Right. Throw the temp gun away.

dont throw it away just burry it deep inside your tool box....

just bolted a full mod in today, what is needed as far as break-in, i won't be running eb fuel all i have is 2 cases of byron's 30%.. is it good to go, or do a few easy tanks... thanks.....

being that your changing fuel you should idle a tank before race tuning.

thanks jpalessi, what would be a good starting point for carb restrictors, got a truggy with a 086 pipe. looking for just a bit over 10 minutes run time on a tank.. thanks...

i run a 7mm in my d8t with rp i feel it makes great power with it and im getting 13min on tank

thanks jbright, i'll probably go in the middle 7.5 and see where i turn out, can't wait to get her going.....

no prob! I've been running the 8mm w/ a 2041 and have been getting over 10mins everywhere. I would try them all and see what fits your driving/car the best.

Hm?????????????????????????