2LikesGo-Tech Engines Thread
02-05-2010 | 04:39 AM
#9916
Well need a new crank for the MG66..
tried the 808 yesterdayand noticed a lot of end play in the clutch bell so yanked the motor to re-shim it and I found the end of the crank has worn down some. Not surprising considering how many sets of clutch bearings I destroyed last year.Bummer none the less. Oh well not an expensive fix and I will be starting the season with an almost new engine again.Not to mention a lighter car.Hoping the new Ascendancy racing 4 shoe clutch should balance out the wear on both bells and bearings too this year.
tried the 808 yesterdayand noticed a lot of end play in the clutch bell so yanked the motor to re-shim it and I found the end of the crank has worn down some. Not surprising considering how many sets of clutch bearings I destroyed last year.Bummer none the less. Oh well not an expensive fix and I will be starting the season with an almost new engine again.Not to mention a lighter car.Hoping the new Ascendancy racing 4 shoe clutch should balance out the wear on both bells and bearings too this year.I'v heard good reports from guys here using that clutch, good luck with it Giz.
02-05-2010 | 12:43 PM
#9918
Tech Adept
Joined: Jul 2008
Posts: 168
From: Rio de Janeiro - Brazil
i question, why is so hard to find a go GX series in US...??
they are out of stock in amain for a long time, i send a email, and they replyed me saying they made the order but don't have a date to recieve the engine.
carolinas rc, the same... they are waiting for the engines.
Ebay: just one guy from taiwan have the GX....
they are out of stock in amain for a long time, i send a email, and they replyed me saying they made the order but don't have a date to recieve the engine.
carolinas rc, the same... they are waiting for the engines.
Ebay: just one guy from taiwan have the GX....
02-05-2010 | 01:09 PM
#9921
02-05-2010 | 02:12 PM
#9922
i question, why is so hard to find a go GX series in US...??
they are out of stock in amain for a long time, i send a email, and they replyed me saying they made the order but don't have a date to recieve the engine.
carolinas rc, the same... they are waiting for the engines.
Ebay: just one guy from taiwan have the GX....
they are out of stock in amain for a long time, i send a email, and they replyed me saying they made the order but don't have a date to recieve the engine.
carolinas rc, the same... they are waiting for the engines.
Ebay: just one guy from taiwan have the GX....
If you check the signatures of most guys on this thread, I'm sure you'l find a www.address that can help you out.
02-05-2010 | 02:46 PM
#9924
Tech Adept
Joined: Aug 2008
Posts: 103
From: upstate ny
Look up 22Racer he is a US go dealer and a great guy t deal with I bet you he has 1 in stock !!!!
Or you can email him at [email protected]
Or you can email him at [email protected]
02-05-2010 | 04:04 PM
#9928
Tech Fanatic
Joined: Aug 2008
Posts: 891
From: Texas
Hey guys- Amain should be receiving them tomorrow or monday. I had a shipment sent to them directly from Taiwan. I just checked the tracking number and the amain stuff is going through customs now.
I currently have GX-3Rs and GX-7Rs in stock, plus GX-5Rs are due tomorrow or monday as well (same ship date).
If you cannot find the GX series at your LHS here in the US, or at your etailer, please have them send me an email at: [email protected] and I will be glad to get them set up as a dealer.
Also, I'm placing orders with the factory twice a month until I'm satisfied with the amount of inventory on-hand. Right now, I pretty much sell out of GX-5Rs by the time I unpack them. So, hence the twice a month order. This is also easier to manage than placing one large order every one or two months. It eats into my margins a bit (shipping, customs, and wire transfer fees), but I'll take the hit to get these things moving.
Guys... please be patient, as I'm trying to get this done right!
I currently have GX-3Rs and GX-7Rs in stock, plus GX-5Rs are due tomorrow or monday as well (same ship date).
If you cannot find the GX series at your LHS here in the US, or at your etailer, please have them send me an email at: [email protected] and I will be glad to get them set up as a dealer.
Also, I'm placing orders with the factory twice a month until I'm satisfied with the amount of inventory on-hand. Right now, I pretty much sell out of GX-5Rs by the time I unpack them. So, hence the twice a month order. This is also easier to manage than placing one large order every one or two months. It eats into my margins a bit (shipping, customs, and wire transfer fees), but I'll take the hit to get these things moving.
Guys... please be patient, as I'm trying to get this done right!
