Sure I do.....

I got my ClockWork Racing modded JL today. Hoping to do some shake down runs on Thursday. Temps here are supposed to go up to 40*f. My engine came with hand fitted piston and sleeve so really no break-in is required. I will take it easy for the first couple of tanks to make sure everything is good.Neal at Clockwork is very professional and a great person to talk to. I got my engine very fast for anyone worried about shipping from Canada to US.

how much?

Hey Aaron what pipe(s) are you going to try? My engine is still sitting It may get a little warmer next week so I will wait. Bumps and Jumps this weekend?

Hey Jud, I'm in NJ, Bumps n Jumps is in PA right? Is their track open for practice this weekend? 40 degrees is balmy weather these days, gotta burn some nitro before Motorama! LMK

$250.00

Bumps and Jumps has practice Thursdays 5pm-9pm. Racing on Sundays for offroad. I will be there this Sunday.

Here is a little low quality clip of my third tank of my Clockwork Racing modded Ofna JL .21 Please don't make fun of the video it was shot by my niece with a $30 DXG camera. Temps outside were 45*f, engine started right up, no shitting and did not shut off once during my running of the engine. Engine temp was around 190* I didn't beat on it much, the piston and sleeve was hand fitted for me so it doesn't need practically any break in. Engine was tested with Dynamite 086 pipe, O'donnell 97T, and Byrons Gen 2 Pro. So far this engine from Clockwork Racing feels incredible. Thanks Neal!!

http://www.youtube.com/watch?v=99EOJegQM5w

Neal just shipped mine (I hope) and I can't wait to get it. I also plan to run it with an 086 pipe and 97T plug. The engine sounds great!!!

That was just conservative on the tune. I don't know where you are located but all I had to do was lean the bottom about 1 turn to bring her in. I can't wait to put her on the track Sunday!!

who's red Acura Aaron ?

Motor looks awesome...i cant wait to run 1 at the next race/

That track looks like fun Engine sounds good, I just got my 2nd JL, they are great little mills!

Aaron your neighbors are gona kick you off the block for making all that rackett!!

daaamnnnn arron that thing looks better than your rb .....only 3tanks! jeeze

Nick that is my 91' Honda CRX SI with a JDM B16A that I wired and installed in front of my house. I had my crx for about 11yrs now.

Engine is awesome I have not even touched the top end yet. I forgot to mentioned that vid was with a steel flywheel too.