If you can not get original RB parts from your local dealer, you can also try to look for novarosi parts, do not remember correct engine name, but there is one, cornoad from which complitely fits RB R3, pin and clip might as well but not sure about that as havnt tried

did rb usa get there shipment yet? i want that new circut 9 motor....

Just a quick question to put my mind at rest. When i'm installing the centax clutch on the v12 j3 i get the desired crankshaft length without shimming behind the flywheel, is this ok or do you have to shim it? If i do shim it i am about .1mm too short, would that be acceptable?

Any help would be great

As long as the flywheel doesn't rub the case, don't shim it.

Thanks mate, i can sleep now

Jamie Corrado, you got pm

The parts are the same as the Novarossi +12-3SCT/CT/ Look into those.

Thanks Uriah, see you at the classic!!

QUOTE=TommyBlazin;5791261]did rb usa get there shipment yet? i want that new circut 9 motor....[/QUOTE]

I spoke with Brìan at RB today, they did get shipment, not. Sure what they got, I'm looking for 2 new C6 cases, anyone else had problems with motor tab breaking?

I ordered a replacement rod for my R3RC (Nova 07601) and I got a Max Power 07601, didn't think anything of it. I put the rod in, put piston and sleeve back together, and it doesn't turn over. The rod gets to the bottom of the case, and gets stuck. I took it back out, and measured the width. The Nova rod is 4.18mm and the new Max rod is 4.21mm. Now the person I ordered it from is telling me they are the same. I'm sure they are supposed to be, but i'm looking at this one and tried it and it's obviously not the same. Anybody know why this would be so off?

I replaced the rod after break in with a Nova 07601 and it worked fine. this max rod is not working.

What size is that? .12 or .21? If it's the .12, the old mugen mt .12 rod will fit. If it's a .21, the fms 07009 is same, I think

I did something wrong, because now it's fine. Thanks to Sam from Kamikaze hobbies for emailing me back and forth until it was right.

Anybody know which shims fit under the head of the MatrixRW motor? I have some Nova shims that work on my R3RC but don't fit on the Matrix.

sirio shims will fit as the matrix is sirio based

Anyone know which Nova shim will work? I can't find any sirio products in any of the online stores I shop at.